# NGW100 customization

if BOARD_ATNGW100_COMMON

config BOARD_ATNGW100_MKII_LCD
	bool "Enable ATNGW100 mkII LCD interface"
	depends on BOARD_ATNGW100_MKII
	help
	  This enables the LCD controller (LCDC) in the AT32AP7000. Since the
	  LCDC is multiplexed with MACB1 (LAN) Ethernet port, only one can be
	  enabled at a time.

	  This choice enables the LCDC and disables the MACB1 interface marked
	  LAN on the PCB.

choice
	prompt "Select an NGW100 add-on board to support"
	default BOARD_ATNGW100_ADDON_NONE

config BOARD_ATNGW100_ADDON_NONE
	bool "None"

config BOARD_ATNGW100_EVKLCD10X
	bool "EVKLCD10X addon board"
	depends on BOARD_ATNGW100_MKI || BOARD_ATNGW100_MKII_LCD
	help
	  This enables support for the EVKLCD100 (QVGA) or EVKLCD101 (VGA)
	  addon board for the NGW100 and NGW100 mkII. By enabling this the LCD
	  controller and AC97 controller is added as platform devices.

config BOARD_ATNGW100_MRMT
	bool "Mediama RMT1/2 add-on board"
	help
	  This enables support for the Mediama RMT1 or RMT2 board.
	  RMT provides LCD support, AC97 codec and other
	  optional peripherals to the Atmel NGW100.

	  This choice disables the detect pin and the write-protect pin for the
	  MCI platform device, since it conflicts with the LCD platform device.
	  The MCI pins can be reenabled by editing the "add device function" but
	  this may break the setup for other displays that use these pins.

endchoice

choice
	prompt "LCD panel resolution on EVKLCD10X"
	depends on BOARD_ATNGW100_EVKLCD10X
	default BOARD_ATNGW100_EVKLCD10X_VGA

config BOARD_ATNGW100_EVKLCD10X_QVGA
	bool "QVGA (320x240)"

config BOARD_ATNGW100_EVKLCD10X_VGA
	bool "VGA (640x480)"

config BOARD_ATNGW100_EVKLCD10X_POW_QVGA
	bool "Powertip QVGA (320x240)"

endchoice

if BOARD_ATNGW100_MRMT
source	"arch/avr32/boards/atngw100/Kconfig_mrmt"
endif

endif	# BOARD_ATNGW100_COMMON