# RMT for NGW100 customization

choice
	prompt "RMT Version"
	help
	  Select the RMTx board version.

config BOARD_MRMT_REV1
	bool "RMT1"
config BOARD_MRMT_REV2
	bool "RMT2"

endchoice

config BOARD_MRMT_AC97
	bool "Enable AC97 CODEC"
	help
	  Enable the UCB1400 AC97 CODEC driver.

choice
	prompt "Touchscreen Driver"
	default BOARD_MRMT_ADS7846_TS

config BOARD_MRMT_UCB1400_TS
	bool "Use UCB1400 Touchscreen"

config BOARD_MRMT_ADS7846_TS
	bool "Use ADS7846 Touchscreen"

endchoice

choice
	prompt "RMTx LCD Selection"
	default BOARD_MRMT_LCD_DISABLE

config BOARD_MRMT_LCD_DISABLE
	bool "LCD Disabled"

config BOARD_MRMT_LCD_LQ043T3DX0X
	bool "Sharp LQ043T3DX0x or compatible"
	help
	  If using RMT2, be sure to load the resistor pack selectors accordingly

if BOARD_MRMT_REV2
config BOARD_MRMT_LCD_KWH043GM08
	bool "Formike KWH043GM08 or compatible"
	help
	  Be sure to load the RMT2 resistor pack selectors accordingly
endif

endchoice

if !BOARD_MRMT_LCD_DISABLE
config BOARD_MRMT_BL_PWM
	bool "Use PWM control for LCD Backlight"
	help
		Use PWM driver for controlling LCD Backlight.
		Otherwise, LCD Backlight is always on.
endif

config BOARD_MRMT_RTC_I2C
	bool "Use External RTC on I2C Bus"
	help
		RMT1 has an optional RTC device on the I2C bus.
		It is a SII S35390A.  Be sure to select the
		matching RTC driver.

choice
	prompt "Wireless Module on ttyS2"
	default BOARD_MRMT_WIRELESS_ZB

config BOARD_MRMT_WIRELESS_ZB
	bool "Use ZigBee/802.15.4 Module"

config BOARD_MRMT_WIRELESS_BT
	bool "Use Bluetooth (HCI) Module"

config BOARD_MRMT_WIRELESS_NONE
	bool "Not Installed"
endchoice