ath9k_hw: Relocate Opmode initialization
Programming the opmode in the HW can be done
before the assoc_id and STA_ID registers are
setup. This helps ath9k_htc when multiple register
writes are used.
Signed-off-by: Sujith <Sujith.Manoharan@atheros.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath9k/hw.c b/drivers/net/wireless/ath/ath9k/hw.c
index 894f5fc..35fe58f 100644
--- a/drivers/net/wireless/ath/ath9k/hw.c
+++ b/drivers/net/wireless/ath/ath9k/hw.c
@@ -1238,6 +1238,8 @@
ath9k_hw_spur_mitigate_freq(ah, chan);
ah->eep_ops->set_board_values(ah, chan);
+ ath9k_hw_set_operating_mode(ah, ah->opmode);
+
REG_WRITE(ah, AR_STA_ID0, get_unaligned_le32(common->macaddr));
REG_WRITE(ah, AR_STA_ID1, get_unaligned_le16(common->macaddr + 4)
| macStaId1
@@ -1245,16 +1247,10 @@
| (ah->config.
ack_6mb ? AR_STA_ID1_ACKCTS_6MB : 0)
| ah->sta_id1_defaults);
- ath9k_hw_set_operating_mode(ah, ah->opmode);
-
ath_hw_setbssidmask(common);
-
REG_WRITE(ah, AR_DEF_ANTENNA, saveDefAntenna);
-
ath9k_hw_write_associd(ah);
-
REG_WRITE(ah, AR_ISR, ~0);
-
REG_WRITE(ah, AR_RSSI_THR, INIT_RSSI_THR);
r = ath9k_hw_rf_set_freq(ah, chan);
