diff --git a/drivers/net/3c503.c b/drivers/net/3c503.c
index cb5ef75..64313e3 100644
--- a/drivers/net/3c503.c
+++ b/drivers/net/3c503.c
@@ -81,7 +81,7 @@
 			 int ring_page);
 static struct ethtool_ops netdev_ethtool_ops;
 
-
+
 /* This routine probes for a memory-mapped 3c503 board by looking for
    the "location register" at the end of the jumpered boot PROM space.
    This works even if a PROM isn't there.
@@ -96,7 +96,7 @@
     int irq = dev->irq;
 
     SET_MODULE_OWNER(dev);
-    
+
     if (base_addr > 0x1ff)	/* Check a single specified location. */
 	return el2_probe1(dev, base_addr);
     else if (base_addr != 0)		/* Don't probe at all. */
@@ -127,7 +127,7 @@
 
 /*  Try all of the locations that aren't obviously empty.  This touches
     a lot of locations, and is much riskier than the code above. */
-static int __init 
+static int __init
 el2_pio_probe(struct net_device *dev)
 {
     int i;
@@ -173,7 +173,7 @@
 /* Probe for the Etherlink II card at I/O port base IOADDR,
    returning non-zero on success.  If found, set the station
    address and memory parameters in DEVICE. */
-static int __init 
+static int __init
 el2_probe1(struct net_device *dev, int ioaddr)
 {
     int i, iobase_reg, membase_reg, saved_406, wordlength, retval;
@@ -367,7 +367,7 @@
     release_region(ioaddr, EL2_IO_EXTENT);
     return retval;
 }
-
+
 static int
 el2_open(struct net_device *dev)
 {
@@ -385,7 +385,7 @@
 		outb_p(0x04 << ((*irqp == 9) ? 2 : *irqp), E33G_IDCFR);
 		outb_p(0x00, E33G_IDCFR);
 		if (*irqp == probe_irq_off(cookie)	/* It's a good IRQ line! */
-		    && ((retval = request_irq(dev->irq = *irqp, 
+		    && ((retval = request_irq(dev->irq = *irqp,
 		    ei_interrupt, 0, dev->name, dev)) == 0))
 		    break;
 	    }