[POWERPC] Fix potential NULL dereference

This patch does fix potential NULL pointer dereference that could take
place inside of strcmp() if of_get_property() call failed.

Signed-off-by: Cyrill Gorcunov <gorcunov@gmail.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
diff --git a/arch/powerpc/platforms/83xx/usb.c b/arch/powerpc/platforms/83xx/usb.c
index eafe760..b45160f 100644
--- a/arch/powerpc/platforms/83xx/usb.c
+++ b/arch/powerpc/platforms/83xx/usb.c
@@ -130,7 +130,7 @@
 	out_be32(immap + MPC83XX_SCCR_OFFS, temp);
 
 	/* Configure pin mux for ULPI.  There is no pin mux for UTMI */
-	if (!strcmp(prop, "ulpi")) {
+	if (prop && !strcmp(prop, "ulpi")) {
 		temp = in_be32(immap + MPC83XX_SICRL_OFFS);
 		temp &= ~MPC831X_SICRL_USB_MASK;
 		temp |= MPC831X_SICRL_USB_ULPI;
@@ -153,13 +153,13 @@
 	usb_regs = ioremap(res.start, res.end - res.start + 1);
 
 	/* Using on-chip PHY */
-	if (!strcmp(prop, "utmi_wide") ||
-			!strcmp(prop, "utmi")) {
+	if (prop && (!strcmp(prop, "utmi_wide") ||
+		     !strcmp(prop, "utmi"))) {
 		/* Set UTMI_PHY_EN, REFSEL to 48MHZ */
 		out_be32(usb_regs + FSL_USB2_CONTROL_OFFS,
 				CONTROL_UTMI_PHY_EN | CONTROL_REFSEL_48MHZ);
 	/* Using external UPLI PHY */
-	} else if (!strcmp(prop, "ulpi")) {
+	} else if (prop && !strcmp(prop, "ulpi")) {
 		/* Set PHY_CLK_SEL to ULPI */
 		temp = CONTROL_PHY_CLK_SEL_ULPI;
 #ifdef CONFIG_USB_OTG