| /****************************************************************************** |
| * |
| * Copyright(c) 2007 - 2010 Realtek Corporation. All rights reserved. |
| * |
| * This program is free software; you can redistribute it and/or modify it |
| * under the terms of version 2 of the GNU General Public License as |
| * published by the Free Software Foundation. |
| * |
| * This program is distributed in the hope that it will be useful, but WITHOUT |
| * ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or |
| * FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for |
| * more details. |
| * |
| * You should have received a copy of the GNU General Public License along with |
| * this program; if not, write to the Free Software Foundation, Inc., |
| * 51 Franklin Street, Fifth Floor, Boston, MA 02110, USA |
| * |
| * Modifications for inclusion into the Linux staging tree are |
| * Copyright(c) 2010 Larry Finger. All rights reserved. |
| * |
| * Contact information: |
| * WLAN FAE <wlanfae@realtek.com> |
| * Larry Finger <Larry.Finger@lwfinger.net> |
| * |
| ******************************************************************************/ |
| #ifndef __RTL8712_GP_BITDEF_H__ |
| #define __RTL8712_GP_BITDEF_H__ |
| |
| /*GPIO_CTRL*/ |
| #define _GPIO_MOD_MSK 0xFF000000 |
| #define _GPIO_MOD_SHT 24 |
| #define _GPIO_IO_SEL_MSK 0x00FF0000 |
| #define _GPIO_IO_SEL_SHT 16 |
| #define _GPIO_OUT_MSK 0x0000FF00 |
| #define _GPIO_OUT_SHT 8 |
| #define _GPIO_IN_MSK 0x000000FF |
| #define _GPIO_IN_SHT 0 |
| |
| /*SYS_PINMUX_CFG*/ |
| #define _GPIOSEL_MSK 0x0003 |
| #define _GPIOSEL_SHT 0 |
| |
| /*LED_CFG*/ |
| #define _LED1SV BIT(7) |
| #define _LED1CM_MSK 0x0070 |
| #define _LED1CM_SHT 4 |
| #define _LED0SV BIT(3) |
| #define _LED0CM_MSK 0x0007 |
| #define _LED0CM_SHT 0 |
| |
| /*PHY_REG*/ |
| #define _HST_RDRDY_SHT 0 |
| #define _HST_RDRDY_MSK 0xFF |
| #define _HST_RDRDY BIT(_HST_RDRDY_SHT) |
| #define _CPU_WTBUSY_SHT 1 |
| #define _CPU_WTBUSY_MSK 0xFF |
| #define _CPU_WTBUSY BIT(_CPU_WTBUSY_SHT) |
| |
| /* 11. General Purpose Registers (Offset: 0x02E0 - 0x02FF)*/ |
| |
| /* 8192S GPIO Config Setting (offset 0x2F1, 1 byte)*/ |
| |
| /*----------------------------------------------------------------------------*/ |
| |
| #define GPIOMUX_EN BIT(3) /* When this bit is set to "1", |
| * GPIO PINs will switch to MAC |
| * GPIO Function |
| */ |
| #define GPIOSEL_GPIO 0 /* UART or JTAG or pure GPIO*/ |
| #define GPIOSEL_PHYDBG 1 /* PHYDBG*/ |
| #define GPIOSEL_BT 2 /* BT_coex*/ |
| #define GPIOSEL_WLANDBG 3 /* WLANDBG*/ |
| #define GPIOSEL_GPIO_MASK (~(BIT(0)|BIT(1))) |
| /* HW Radio OFF switch (GPIO BIT) */ |
| #define HAL_8192S_HW_GPIO_OFF_BIT BIT(3) |
| #define HAL_8192S_HW_GPIO_OFF_MASK 0xF7 |
| #define HAL_8192S_HW_GPIO_WPS_BIT BIT(4) |
| |
| #endif /*__RTL8712_GP_BITDEF_H__*/ |
| |