net: aquantia: Bad udp rate on default interrupt coalescing
Default Tx rates cause very long ISR delays on Tx.
0xff is 510us delay, giving only ~ 2000 interrupts per seconds for
Tx rings cleanup. With these settings udp tx rate was never higher than
~800Mbps on a single stream. Changing min delay to 0xF makes it
way better with ~6Gbps
TCP stream performance is almost unaffected by this change, since LSO
optimizations play important role.
CPU load is affected insignificantly by this change.
Signed-off-by: Pavel Belous <pavel.belous@aquantia.com>
Signed-off-by: Igor Russkikh <igor.russkikh@aquantia.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/aquantia/atlantic/hw_atl/hw_atl_b0.c b/drivers/net/ethernet/aquantia/atlantic/hw_atl/hw_atl_b0.c
index 11f7e71..ec68c20 100644
--- a/drivers/net/ethernet/aquantia/atlantic/hw_atl/hw_atl_b0.c
+++ b/drivers/net/ethernet/aquantia/atlantic/hw_atl/hw_atl_b0.c
@@ -821,12 +821,12 @@ static int hw_atl_b0_hw_interrupt_moderation_set(struct aq_hw_s *self)
itr_rx |= rx_max_timer << 0x10U;
} else {
static unsigned int hw_atl_b0_timers_table_tx_[][2] = {
- {0xffU, 0xffU}, /* 10Gbit */
- {0xffU, 0x1ffU}, /* 5Gbit */
- {0xffU, 0x1ffU}, /* 5Gbit 5GS */
- {0xffU, 0x1ffU}, /* 2.5Gbit */
- {0xffU, 0x1ffU}, /* 1Gbit */
- {0xffU, 0x1ffU}, /* 100Mbit */
+ {0xfU, 0xffU}, /* 10Gbit */
+ {0xfU, 0x1ffU}, /* 5Gbit */
+ {0xfU, 0x1ffU}, /* 5Gbit 5GS */
+ {0xfU, 0x1ffU}, /* 2.5Gbit */
+ {0xfU, 0x1ffU}, /* 1Gbit */
+ {0xfU, 0x1ffU}, /* 100Mbit */
};
static unsigned int hw_atl_b0_timers_table_rx_[][2] = {
