regulator: s5m8767: Implement voltage setting for BUCK7/8 regulators
Voltage setting for BUCK7 and BUCK8 was not supported by s5m8767 driver.
If they were configured in DTS then the driver probing would fail with
EINVAL:
[ 0.288474] VCC_SUB_1.35V: failed to apply 1350000uV constraint
[ 0.288671] s5m8767-pmic s5m8767-pmic: regulator init failed for 35
[ 0.294931] s5m8767-pmic: probe of s5m8767-pmic failed with error -22
This patch adds support for BUCK7 and BUCK8 regulators using standard
regmap get/set voltage sel functions.
Signed-off-by: Krzysztof Kozlowski <k.kozlowski@samsung.com>
Reviewed-by: Sachin Kamat <sachin.kamat@linaro.org>
Signed-off-by: Mark Brown <broonie@linaro.org>
diff --git a/drivers/regulator/s5m8767.c b/drivers/regulator/s5m8767.c
index ef4da44..9b14faa 100644
--- a/drivers/regulator/s5m8767.c
+++ b/drivers/regulator/s5m8767.c
@@ -120,8 +120,8 @@
[S5M8767_BUCK4] = &buck_voltage_val2,
[S5M8767_BUCK5] = &buck_voltage_val1,
[S5M8767_BUCK6] = &buck_voltage_val1,
- [S5M8767_BUCK7] = NULL,
- [S5M8767_BUCK8] = NULL,
+ [S5M8767_BUCK7] = &buck_voltage_val3,
+ [S5M8767_BUCK8] = &buck_voltage_val3,
[S5M8767_BUCK9] = &buck_voltage_val3,
};
@@ -418,9 +418,12 @@
};
static struct regulator_ops s5m8767_buck78_ops = {
+ .list_voltage = regulator_list_voltage_linear,
.is_enabled = s5m8767_reg_is_enabled,
.enable = s5m8767_reg_enable,
.disable = s5m8767_reg_disable,
+ .get_voltage_sel = regulator_get_voltage_sel_regmap,
+ .set_voltage_sel = regulator_set_voltage_sel_regmap,
};
#define s5m8767_regulator_desc(_name) { \
