blob: 8c6a0b8e113133c127b1505c61e09ff1d347d551 [file] [log] [blame]
What: /sys/class/leds/dell::kbd_backlight/als_enabled
Date: December 2014
KernelVersion: 3.19
Contact: Gabriele Mazzotta <gabriele.mzt@gmail.com>,
Pali Rohár <pali.rohar@gmail.com>
Description:
This file allows to control the automatic keyboard
illumination mode on some systems that have an ambient
light sensor. Write 1 to this file to enable the auto
mode, 0 to disable it.
What: /sys/class/leds/dell::kbd_backlight/als_setting
Date: December 2014
KernelVersion: 3.19
Contact: Gabriele Mazzotta <gabriele.mzt@gmail.com>,
Pali Rohár <pali.rohar@gmail.com>
Description:
This file allows to specifiy the on/off threshold value,
as reported by the ambient light sensor.
What: /sys/class/leds/dell::kbd_backlight/start_triggers
Date: December 2014
KernelVersion: 3.19
Contact: Gabriele Mazzotta <gabriele.mzt@gmail.com>,
Pali Rohár <pali.rohar@gmail.com>
Description:
This file allows to control the input triggers that
turn on the keyboard backlight illumination that is
disabled because of inactivity.
Read the file to see the triggers available. The ones
enabled are preceded by '+', those disabled by '-'.
To enable a trigger, write its name preceded by '+' to
this file. To disable a trigger, write its name preceded
by '-' instead.
For example, to enable the keyboard as trigger run:
echo +keyboard > /sys/class/leds/dell::kbd_backlight/start_triggers
To disable it:
echo -keyboard > /sys/class/leds/dell::kbd_backlight/start_triggers
Note that not all the available triggers can be configured.
What: /sys/class/leds/dell::kbd_backlight/stop_timeout
Date: December 2014
KernelVersion: 3.19
Contact: Gabriele Mazzotta <gabriele.mzt@gmail.com>,
Pali Rohár <pali.rohar@gmail.com>
Description:
This file allows to specify the interval after which the
keyboard illumination is disabled because of inactivity.
The timeouts are expressed in seconds, minutes, hours and
days, for which the symbols are 's', 'm', 'h' and 'd'
respectively.
To configure the timeout, write to this file a value along
with any the above units. If no unit is specified, the value
is assumed to be expressed in seconds.
For example, to set the timeout to 10 minutes run:
echo 10m > /sys/class/leds/dell::kbd_backlight/stop_timeout
Note that when this file is read, the returned value might be
expressed in a different unit than the one used when the timeout
was set.
Also note that only some timeouts are supported and that
some systems might fall back to a specific timeout in case
an invalid timeout is written to this file.