ide: add support for CFA specified transfer modes (take 3)
Add support for the CompactFlash specific PIO modes 5/6 and MWDMA modes 3/4.
Since there were no PIO5 capable hard drives produced and one would also need
66 MHz IDE clock to actually get the difference WRT the address setup timings
programmed, I decided to simply replace the old non-standard PIO mode 5 timings
with the CFA specified ones.
Signed-off-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Cc: stf_xl@wp.pl
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
diff --git a/drivers/ide/ide-dma.c b/drivers/ide/ide-dma.c
index f9c9175..a0b8cab1 100644
--- a/drivers/ide/ide-dma.c
+++ b/drivers/ide/ide-dma.c
@@ -261,6 +261,14 @@
break;
case XFER_MW_DMA_0:
mask = id[ATA_ID_MWDMA_MODES];
+
+ /* Also look for the CF specific MWDMA modes... */
+ if (ata_id_is_cfa(id) && (id[ATA_ID_CFA_MODES] & 0x38)) {
+ u8 mode = ((id[ATA_ID_CFA_MODES] & 0x38) >> 3) - 1;
+
+ mask |= ((2 << mode) - 1) << 3;
+ }
+
if (port_ops && port_ops->mdma_filter)
mask &= port_ops->mdma_filter(drive);
else
