| /* SPDX-License-Identifier: GPL-2.0 */ | |
| #ifndef OLPC_DCON_H_ | |
| #define OLPC_DCON_H_ | |
| #include <linux/notifier.h> | |
| #include <linux/workqueue.h> | |
| /* DCON registers */ | |
| #define DCON_REG_ID 0 | |
| #define DCON_REG_MODE 1 | |
| #define MODE_PASSTHRU (1<<0) | |
| #define MODE_SLEEP (1<<1) | |
| #define MODE_SLEEP_AUTO (1<<2) | |
| #define MODE_BL_ENABLE (1<<3) | |
| #define MODE_BLANK (1<<4) | |
| #define MODE_CSWIZZLE (1<<5) | |
| #define MODE_COL_AA (1<<6) | |
| #define MODE_MONO_LUMA (1<<7) | |
| #define MODE_SCAN_INT (1<<8) | |
| #define MODE_CLOCKDIV (1<<9) | |
| #define MODE_DEBUG (1<<14) | |
| #define MODE_SELFTEST (1<<15) | |
| #define DCON_REG_HRES 0x2 | |
| #define DCON_REG_HTOTAL 0x3 | |
| #define DCON_REG_HSYNC_WIDTH 0x4 | |
| #define DCON_REG_VRES 0x5 | |
| #define DCON_REG_VTOTAL 0x6 | |
| #define DCON_REG_VSYNC_WIDTH 0x7 | |
| #define DCON_REG_TIMEOUT 0x8 | |
| #define DCON_REG_SCAN_INT 0x9 | |
| #define DCON_REG_BRIGHT 0xa | |
| #define DCON_REG_MEM_OPT_A 0x41 | |
| #define DCON_REG_MEM_OPT_B 0x42 | |
| /* Load Delay Locked Loop (DLL) settings for clock delay */ | |
| #define MEM_DLL_CLOCK_DELAY (1<<0) | |
| /* Memory controller power down function */ | |
| #define MEM_POWER_DOWN (1<<8) | |
| /* Memory controller software reset */ | |
| #define MEM_SOFT_RESET (1<<0) | |
| /* Status values */ | |
| #define DCONSTAT_SCANINT 0 | |
| #define DCONSTAT_SCANINT_DCON 1 | |
| #define DCONSTAT_DISPLAYLOAD 2 | |
| #define DCONSTAT_MISSED 3 | |
| /* Source values */ | |
| #define DCON_SOURCE_DCON 0 | |
| #define DCON_SOURCE_CPU 1 | |
| /* Interrupt */ | |
| #define DCON_IRQ 6 | |
| struct dcon_priv { | |
| struct i2c_client *client; | |
| struct fb_info *fbinfo; | |
| struct backlight_device *bl_dev; | |
| wait_queue_head_t waitq; | |
| struct work_struct switch_source; | |
| struct notifier_block reboot_nb; | |
| /* Shadow register for the DCON_REG_MODE register */ | |
| u8 disp_mode; | |
| /* The current backlight value - this saves us some smbus traffic */ | |
| u8 bl_val; | |
| /* Current source, initialized at probe time */ | |
| int curr_src; | |
| /* Desired source */ | |
| int pending_src; | |
| /* Variables used during switches */ | |
| bool switched; | |
| ktime_t irq_time; | |
| ktime_t load_time; | |
| /* Current output type; true == mono, false == color */ | |
| bool mono; | |
| bool asleep; | |
| /* This get set while controlling fb blank state from the driver */ | |
| bool ignore_fb_events; | |
| }; | |
| struct dcon_platform_data { | |
| int (*init)(struct dcon_priv *); | |
| void (*bus_stabilize_wiggle)(void); | |
| void (*set_dconload)(int); | |
| int (*read_status)(u8 *); | |
| }; | |
| #include <linux/interrupt.h> | |
| irqreturn_t dcon_interrupt(int irq, void *id); | |
| #ifdef CONFIG_FB_OLPC_DCON_1 | |
| extern struct dcon_platform_data dcon_pdata_xo_1; | |
| #endif | |
| #ifdef CONFIG_FB_OLPC_DCON_1_5 | |
| extern struct dcon_platform_data dcon_pdata_xo_1_5; | |
| #endif | |
| #endif |