mmc: core: Allow setting CMD timeout for CMD6 (SWITCH).
CMD6 is an R1B-type command, where DAT is used as busy. Depending
on register written using CMD6, timeout value can be different
as per spec.
Signed-off-by: Andrei Warkentin <andreiw@motorola.com>
Signed-off-by: Chris Ball <cjb@laptop.org>
diff --git a/drivers/mmc/core/mmc.c b/drivers/mmc/core/mmc.c
index ae6b8fd..396cb23 100644
--- a/drivers/mmc/core/mmc.c
+++ b/drivers/mmc/core/mmc.c
@@ -548,7 +548,7 @@
*/
if (card->ext_csd.enhanced_area_en) {
err = mmc_switch(card, EXT_CSD_CMD_SET_NORMAL,
- EXT_CSD_ERASE_GROUP_DEF, 1);
+ EXT_CSD_ERASE_GROUP_DEF, 1, 0);
if (err && err != -EBADMSG)
goto free_card;
@@ -579,7 +579,7 @@
if (card->ext_csd.bootconfig & 0x7) {
card->ext_csd.bootconfig &= ~0x7;
mmc_switch(card, EXT_CSD_CMD_SET_NORMAL, EXT_CSD_BOOT_CONFIG,
- card->ext_csd.bootconfig);
+ card->ext_csd.bootconfig, 0);
}
/*
@@ -588,7 +588,7 @@
if ((card->ext_csd.hs_max_dtr != 0) &&
(host->caps & MMC_CAP_MMC_HIGHSPEED)) {
err = mmc_switch(card, EXT_CSD_CMD_SET_NORMAL,
- EXT_CSD_HS_TIMING, 1);
+ EXT_CSD_HS_TIMING, 1, 0);
if (err && err != -EBADMSG)
goto free_card;
@@ -655,7 +655,8 @@
ddr = 0; /* no DDR for 1-bit width */
err = mmc_switch(card, EXT_CSD_CMD_SET_NORMAL,
EXT_CSD_BUS_WIDTH,
- ext_csd_bits[idx][0]);
+ ext_csd_bits[idx][0],
+ 0);
if (!err) {
mmc_set_bus_width_ddr(card->host,
bus_width, MMC_SDR_MODE);
@@ -674,8 +675,9 @@
if (!err && ddr) {
err = mmc_switch(card, EXT_CSD_CMD_SET_NORMAL,
- EXT_CSD_BUS_WIDTH,
- ext_csd_bits[idx][1]);
+ EXT_CSD_BUS_WIDTH,
+ ext_csd_bits[idx][1],
+ 0);
}
if (err) {
printk(KERN_WARNING "%s: switch to bus width %d ddr %d "
