Documentation cleanup: trivial misspelling, punctuation, and grammar corrections.
Cc: Randy Dunlap <randy.dunlap@oracle.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/Documentation/powerpc/booting-without-of.txt b/Documentation/powerpc/booting-without-of.txt
index 99514ce..928a79c 100644
--- a/Documentation/powerpc/booting-without-of.txt
+++ b/Documentation/powerpc/booting-without-of.txt
@@ -708,7 +708,7 @@
In general, the format of an address for a device is defined by the
parent bus type, based on the #address-cells and #size-cells
properties. Note that the parent's parent definitions of #address-cells
-and #size-cells are not inhereted so every node with children must specify
+and #size-cells are not inherited so every node with children must specify
them. The kernel requires the root node to have those properties defining
addresses format for devices directly mapped on the processor bus.
@@ -1777,7 +1777,7 @@
Xilinx uartlite devices are simple fixed speed serial ports.
- Requred properties:
+ Required properties:
- current-speed : Baud rate of uartlite
v) Xilinx hwicap
@@ -1799,7 +1799,7 @@
Xilinx UART 16550 devices are very similar to the NS16550 but with
different register spacing and an offset from the base address.
- Requred properties:
+ Required properties:
- clock-frequency : Frequency of the clock input
- reg-offset : A value of 3 is required
- reg-shift : A value of 2 is required
@@ -1953,7 +1953,7 @@
1) The /system-controller node
This node is used to represent the system-controller and must be
- present when the system uses a system contller chip. The top-level
+ present when the system uses a system controller chip. The top-level
system-controller node contains information that is global to all
devices within the system controller chip. The node name begins
with "system-controller" followed by the unit address, which is
