| config WILC1000 |
| tristate "WILC1000 support (WiFi only)" |
| depends on BROKEN |
| depends on !S390 |
| depends on CFG80211 && WEXT_CORE && INET |
| depends on MMC || SPI |
| ---help--- |
| This module only support IEEE 802.11n WiFi. |
| |
| choice |
| prompt "Memory Allocation" |
| depends on WILC1000 |
| default WILC1000_PREALLOCATE_AT_LOADING_DRIVER |
| |
| config WILC1000_PREALLOCATE_AT_LOADING_DRIVER |
| bool "Preallocate memory at loading driver" |
| ---help--- |
| This choice supports static allocation of the memory |
| for the receive buffer. The driver will allocate the RX buffer |
| during initial time. The driver will also free the buffer |
| by calling network device stop. |
| |
| config WILC1000_DYNAMICALLY_ALLOCATE_MEMROY |
| bool "Dynamically allocate memory in real time" |
| ---help--- |
| This choice supports dynamic allocation of the memory |
| for the receive buffer. The driver will allocate the RX buffer |
| when it is required. |
| endchoice |
| |
| choice |
| prompt "Bus Type" |
| depends on WILC1000 |
| default WILC1000_SDIO |
| |
| config WILC1000_SDIO |
| bool "SDIO support" |
| depends on MMC |
| ---help--- |
| This module adds support for the SDIO interface of adapters using |
| WILC1000 chipset. The Atmel WILC1000 SDIO is a full speed interface. |
| It meets SDIO card specification version 2.0. The interface supports |
| the 1-bit/4-bit SD transfer mode at the clock range of 0-50 MHz. |
| The host can use this interface to read and write from any register |
| within the chip as well as configure the WILC1000 for data DMA. |
| To use this interface, pin9 (SDIO_SPI_CFG) must be grounded. Select |
| this if your platform is using the SDIO bus. |
| |
| config WILC1000_SPI |
| depends on SPI |
| bool "SPI support" |
| ---help--- |
| This module adds support for the SPI interface of adapters using |
| WILC1000 chipset. The Atmel WILC1000 has a Serial Peripheral |
| Interface (SPI) that operates as a SPI slave. This SPI interface can |
| be used for control and for serial I/O of 802.11 data. The SPI is a |
| full-duplex slave synchronous serial interface that is available |
| immediately following reset when pin 9 (SDIO_SPI_CFG) is tied to |
| VDDIO. Select this if your platform is using the SPI bus. |
| endchoice |
| |
| config WILC1000_HW_OOB_INTR |
| bool "Use out of band interrupt" |
| depends on WILC1000 && WILC1000_SDIO |
| default n |
| ---help--- |
| This option enables out-of-band interrupt support for the WILC1000 |
| chipset. This OOB interrupt is intended to provide a faster interrupt |
| mechanism for SDIO host controllers that don't support SDIO interrupt. |
| Select this option If the SDIO host controller in your platform |
| doesn't support SDIO time devision interrupt. |
