| USB PHY | |
| OMAP USB2 PHY | |
| Required properties: | |
| - compatible: Should be "ti,omap-usb2" | |
| - reg : Address and length of the register set for the device. | |
| - #phy-cells: determine the number of cells that should be given in the | |
| phandle while referencing this phy. | |
| Optional properties: | |
| - ctrl-module : phandle of the control module used by PHY driver to power on | |
| the PHY. | |
| This is usually a subnode of ocp2scp to which it is connected. | |
| usb2phy@4a0ad080 { | |
| compatible = "ti,omap-usb2"; | |
| reg = <0x4a0ad080 0x58>; | |
| ctrl-module = <&omap_control_usb>; | |
| #phy-cells = <0>; | |
| }; | |
| OMAP USB3 PHY | |
| Required properties: | |
| - compatible: Should be "ti,omap-usb3" | |
| - reg : Address and length of the register set for the device. | |
| - reg-names: The names of the register addresses corresponding to the registers | |
| filled in "reg". | |
| - #phy-cells: determine the number of cells that should be given in the | |
| phandle while referencing this phy. | |
| Optional properties: | |
| - ctrl-module : phandle of the control module used by PHY driver to power on | |
| the PHY. | |
| This is usually a subnode of ocp2scp to which it is connected. | |
| usb3phy@4a084400 { | |
| compatible = "ti,omap-usb3"; | |
| reg = <0x4a084400 0x80>, | |
| <0x4a084800 0x64>, | |
| <0x4a084c00 0x40>; | |
| reg-names = "phy_rx", "phy_tx", "pll_ctrl"; | |
| ctrl-module = <&omap_control_usb>; | |
| #phy-cells = <0>; | |
| }; |