| /* |
| * include/linux/platform_data/pxa_sdhci.h |
| * |
| * Copyright 2010 Marvell |
| * Zhangfei Gao <zhangfei.gao@marvell.com> |
| * |
| * PXA Platform - SDHCI platform data definitions |
| * |
| * This program is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License version 2 as |
| * published by the Free Software Foundation. |
| */ |
| |
| #ifndef _PXA_SDHCI_H_ |
| #define _PXA_SDHCI_H_ |
| |
| /* pxa specific flag */ |
| /* Require clock free running */ |
| #define PXA_FLAG_ENABLE_CLOCK_GATING (1<<0) |
| /* card always wired to host, like on-chip emmc */ |
| #define PXA_FLAG_CARD_PERMANENT (1<<1) |
| /* Board design supports 8-bit data on SD/SDIO BUS */ |
| #define PXA_FLAG_SD_8_BIT_CAPABLE_SLOT (1<<2) |
| |
| /* |
| * struct pxa_sdhci_platdata() - Platform device data for PXA SDHCI |
| * @flags: flags for platform requirement |
| * @clk_delay_cycles: |
| * mmp2: each step is roughly 100ps, 5bits width |
| * pxa910: each step is 1ns, 4bits width |
| * @clk_delay_sel: select clk_delay, used on pxa910 |
| * 0: choose feedback clk |
| * 1: choose feedback clk + delay value |
| * 2: choose internal clk |
| * @clk_delay_enable: enable clk_delay or not, used on pxa910 |
| * @ext_cd_gpio: gpio pin used for external CD line |
| * @ext_cd_gpio_invert: invert values for external CD gpio line |
| * @max_speed: the maximum speed supported |
| * @host_caps: Standard MMC host capabilities bit field. |
| * @quirks: quirks of platfrom |
| * @pm_caps: pm_caps of platfrom |
| */ |
| struct sdhci_pxa_platdata { |
| unsigned int flags; |
| unsigned int clk_delay_cycles; |
| unsigned int clk_delay_sel; |
| bool clk_delay_enable; |
| unsigned int ext_cd_gpio; |
| bool ext_cd_gpio_invert; |
| unsigned int max_speed; |
| unsigned int host_caps; |
| unsigned int quirks; |
| unsigned int pm_caps; |
| }; |
| |
| struct sdhci_pxa { |
| u8 clk_enable; |
| u8 power_mode; |
| }; |
| #endif /* _PXA_SDHCI_H_ */ |
