cpufreq: cpu0: OPPs can be populated at runtime
OPPs can be populated statically, via DT, or added at run time with
dev_pm_opp_add().
While this driver handles the first case correctly, it would fail to populate
OPPs added at runtime. Because call to of_init_opp_table() would fail as there
are no OPPs in DT and probe will return early.
To fix this, remove error checking and call dev_pm_opp_init_cpufreq_table()
unconditionally.
Update bindings as well.
Suggested-by: Stephen Boyd <sboyd@codeaurora.org>
Tested-by: Stephen Boyd <sboyd@codeaurora.org>
Signed-off-by: Viresh Kumar <viresh.kumar@linaro.org>
Acked-by: Santosh Shilimkar <santosh.shilimkar@ti.com>
Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
diff --git a/Documentation/devicetree/bindings/cpufreq/cpufreq-cpu0.txt b/Documentation/devicetree/bindings/cpufreq/cpufreq-cpu0.txt
index f055515..366690c 100644
--- a/Documentation/devicetree/bindings/cpufreq/cpufreq-cpu0.txt
+++ b/Documentation/devicetree/bindings/cpufreq/cpufreq-cpu0.txt
@@ -8,10 +8,12 @@
under node /cpus/cpu@0.
Required properties:
-- operating-points: Refer to Documentation/devicetree/bindings/power/opp.txt
- for details
+- None
Optional properties:
+- operating-points: Refer to Documentation/devicetree/bindings/power/opp.txt for
+ details. OPPs *must* be supplied either via DT, i.e. this property, or
+ populated at runtime.
- clock-latency: Specify the possible maximum transition latency for clock,
in unit of nanoseconds.
- voltage-tolerance: Specify the CPU voltage tolerance in percentage.
diff --git a/drivers/cpufreq/cpufreq-cpu0.c b/drivers/cpufreq/cpufreq-cpu0.c
index ee1ae30..86beda9 100644
--- a/drivers/cpufreq/cpufreq-cpu0.c
+++ b/drivers/cpufreq/cpufreq-cpu0.c
@@ -152,11 +152,8 @@
goto out_put_reg;
}
- ret = of_init_opp_table(cpu_dev);
- if (ret) {
- pr_err("failed to init OPP table: %d\n", ret);
- goto out_put_clk;
- }
+ /* OPPs might be populated at runtime, don't check for error here */
+ of_init_opp_table(cpu_dev);
ret = dev_pm_opp_init_cpufreq_table(cpu_dev, &freq_table);
if (ret) {
