| /* | |
| * Standard pin control state definitions | |
| */ | |
| /** | |
| * @PINCTRL_STATE_DEFAULT: the state the pinctrl handle shall be put | |
| * into as default, usually this means the pins are up and ready to | |
| * be used by the device driver. This state is commonly used by | |
| * hogs to configure muxing and pins at boot, and also as a state | |
| * to go into when returning from sleep and idle in | |
| * .pm_runtime_resume() or ordinary .resume() for example. | |
| * @PINCTRL_STATE_IDLE: the state the pinctrl handle shall be put into | |
| * when the pins are idle. This is a state where the system is relaxed | |
| * but not fully sleeping - some power may be on but clocks gated for | |
| * example. Could typically be set from a pm_runtime_suspend() or | |
| * pm_runtime_idle() operation. | |
| * @PINCTRL_STATE_SLEEP: the state the pinctrl handle shall be put into | |
| * when the pins are sleeping. This is a state where the system is in | |
| * its lowest sleep state. Could typically be set from an | |
| * ordinary .suspend() function. | |
| */ | |
| #define PINCTRL_STATE_DEFAULT "default" | |
| #define PINCTRL_STATE_IDLE "idle" | |
| #define PINCTRL_STATE_SLEEP "sleep" |