| /* |
| * Definitions for RTL818x hardware |
| * |
| * Copyright 2007 Michael Wu <flamingice@sourmilk.net> |
| * Copyright 2007 Andrea Merello <andreamrl@tiscali.it> |
| * |
| * Based on the r8187 driver, which is: |
| * Copyright 2005 Andrea Merello <andreamrl@tiscali.it>, et al. |
| * |
| * This program is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License version 2 as |
| * published by the Free Software Foundation. |
| */ |
| |
| #ifndef RTL818X_H |
| #define RTL818X_H |
| |
| struct rtl818x_csr { |
| u8 MAC[6]; |
| u8 reserved_0[2]; |
| __le32 MAR[2]; |
| u8 RX_FIFO_COUNT; |
| u8 reserved_1; |
| u8 TX_FIFO_COUNT; |
| u8 BQREQ; |
| u8 reserved_2[4]; |
| __le32 TSFT[2]; |
| __le32 TLPDA; |
| __le32 TNPDA; |
| __le32 THPDA; |
| __le16 BRSR; |
| u8 BSSID[6]; |
| u8 RESP_RATE; |
| u8 EIFS; |
| u8 reserved_3[1]; |
| u8 CMD; |
| #define RTL818X_CMD_TX_ENABLE (1 << 2) |
| #define RTL818X_CMD_RX_ENABLE (1 << 3) |
| #define RTL818X_CMD_RESET (1 << 4) |
| u8 reserved_4[4]; |
| __le16 INT_MASK; |
| __le16 INT_STATUS; |
| #define RTL818X_INT_RX_OK (1 << 0) |
| #define RTL818X_INT_RX_ERR (1 << 1) |
| #define RTL818X_INT_TXL_OK (1 << 2) |
| #define RTL818X_INT_TXL_ERR (1 << 3) |
| #define RTL818X_INT_RX_DU (1 << 4) |
| #define RTL818X_INT_RX_FO (1 << 5) |
| #define RTL818X_INT_TXN_OK (1 << 6) |
| #define RTL818X_INT_TXN_ERR (1 << 7) |
| #define RTL818X_INT_TXH_OK (1 << 8) |
| #define RTL818X_INT_TXH_ERR (1 << 9) |
| #define RTL818X_INT_TXB_OK (1 << 10) |
| #define RTL818X_INT_TXB_ERR (1 << 11) |
| #define RTL818X_INT_ATIM (1 << 12) |
| #define RTL818X_INT_BEACON (1 << 13) |
| #define RTL818X_INT_TIME_OUT (1 << 14) |
| #define RTL818X_INT_TX_FO (1 << 15) |
| __le32 TX_CONF; |
| #define RTL818X_TX_CONF_LOOPBACK_MAC (1 << 17) |
| #define RTL818X_TX_CONF_NO_ICV (1 << 19) |
| #define RTL818X_TX_CONF_DISCW (1 << 20) |
| #define RTL818X_TX_CONF_R8180_ABCD (2 << 25) |
| #define RTL818X_TX_CONF_R8180_F (3 << 25) |
| #define RTL818X_TX_CONF_R8185_ABC (4 << 25) |
| #define RTL818X_TX_CONF_R8185_D (5 << 25) |
| #define RTL818X_TX_CONF_HWVER_MASK (7 << 25) |
| #define RTL818X_TX_CONF_CW_MIN (1 << 31) |
| __le32 RX_CONF; |
| #define RTL818X_RX_CONF_MONITOR (1 << 0) |
| #define RTL818X_RX_CONF_NICMAC (1 << 1) |
| #define RTL818X_RX_CONF_MULTICAST (1 << 2) |
| #define RTL818X_RX_CONF_BROADCAST (1 << 3) |
| #define RTL818X_RX_CONF_FCS (1 << 5) |
| #define RTL818X_RX_CONF_DATA (1 << 18) |
| #define RTL818X_RX_CONF_CTRL (1 << 19) |
| #define RTL818X_RX_CONF_MGMT (1 << 20) |
| #define RTL818X_RX_CONF_BSSID (1 << 23) |
| #define RTL818X_RX_CONF_RX_AUTORESETPHY (1 << 28) |
| #define RTL818X_RX_CONF_ONLYERLPKT (1 << 31) |
| __le32 INT_TIMEOUT; |
| __le32 TBDA; |
| u8 EEPROM_CMD; |
| #define RTL818X_EEPROM_CMD_READ (1 << 0) |
| #define RTL818X_EEPROM_CMD_WRITE (1 << 1) |
| #define RTL818X_EEPROM_CMD_CK (1 << 2) |
| #define RTL818X_EEPROM_CMD_CS (1 << 3) |
| #define RTL818X_EEPROM_CMD_NORMAL (0 << 6) |
| #define RTL818X_EEPROM_CMD_LOAD (1 << 6) |
| #define RTL818X_EEPROM_CMD_PROGRAM (2 << 6) |
| #define RTL818X_EEPROM_CMD_CONFIG (3 << 6) |
| u8 CONFIG0; |
| u8 CONFIG1; |
| u8 CONFIG2; |
| __le32 ANAPARAM; |
| u8 MSR; |
| #define RTL818X_MSR_NO_LINK (0 << 2) |
| #define RTL818X_MSR_ADHOC (1 << 2) |
| #define RTL818X_MSR_INFRA (2 << 2) |
| u8 CONFIG3; |
| #define RTL818X_CONFIG3_ANAPARAM_WRITE (1 << 6) |
| u8 CONFIG4; |
| #define RTL818X_CONFIG4_POWEROFF (1 << 6) |
| #define RTL818X_CONFIG4_VCOOFF (1 << 7) |
| u8 TESTR; |
| u8 reserved_9[2]; |
| __le16 PGSELECT; |
| __le32 ANAPARAM2; |
| u8 reserved_10[12]; |
| __le16 BEACON_INTERVAL; |
| __le16 ATIM_WND; |
| __le16 BEACON_INTERVAL_TIME; |
| __le16 ATIMTR_INTERVAL; |
| u8 reserved_11[4]; |
| u8 PHY[4]; |
| __le16 RFPinsOutput; |
| __le16 RFPinsEnable; |
| __le16 RFPinsSelect; |
| __le16 RFPinsInput; |
| __le32 RF_PARA; |
| __le32 RF_TIMING; |
| u8 GP_ENABLE; |
| u8 GPIO; |
| u8 reserved_12[10]; |
| u8 TX_AGC_CTL; |
| #define RTL818X_TX_AGC_CTL_PERPACKET_GAIN_SHIFT (1 << 0) |
| #define RTL818X_TX_AGC_CTL_PERPACKET_ANTSEL_SHIFT (1 << 1) |
| #define RTL818X_TX_AGC_CTL_FEEDBACK_ANT (1 << 2) |
| u8 TX_GAIN_CCK; |
| u8 TX_GAIN_OFDM; |
| u8 TX_ANTENNA; |
| u8 reserved_13[16]; |
| u8 WPA_CONF; |
| u8 reserved_14[3]; |
| u8 SIFS; |
| u8 DIFS; |
| u8 SLOT; |
| u8 reserved_15[5]; |
| u8 CW_CONF; |
| #define RTL818X_CW_CONF_PERPACKET_CW_SHIFT (1 << 0) |
| #define RTL818X_CW_CONF_PERPACKET_RETRY_SHIFT (1 << 1) |
| u8 CW_VAL; |
| u8 RATE_FALLBACK; |
| u8 reserved_16[25]; |
| u8 CONFIG5; |
| u8 TX_DMA_POLLING; |
| u8 reserved_17[2]; |
| __le16 CWR; |
| u8 RETRY_CTR; |
| u8 reserved_18[5]; |
| __le32 RDSAR; |
| u8 reserved_19[18]; |
| u16 TALLY_CNT; |
| u8 TALLY_SEL; |
| } __attribute__((packed)); |
| |
| static const struct ieee80211_rate rtl818x_rates[] = { |
| { .rate = 10, |
| .val = 0, |
| .flags = IEEE80211_RATE_CCK }, |
| { .rate = 20, |
| .val = 1, |
| .flags = IEEE80211_RATE_CCK }, |
| { .rate = 55, |
| .val = 2, |
| .flags = IEEE80211_RATE_CCK }, |
| { .rate = 110, |
| .val = 3, |
| .flags = IEEE80211_RATE_CCK }, |
| { .rate = 60, |
| .val = 4, |
| .flags = IEEE80211_RATE_OFDM }, |
| { .rate = 90, |
| .val = 5, |
| .flags = IEEE80211_RATE_OFDM }, |
| { .rate = 120, |
| .val = 6, |
| .flags = IEEE80211_RATE_OFDM }, |
| { .rate = 180, |
| .val = 7, |
| .flags = IEEE80211_RATE_OFDM }, |
| { .rate = 240, |
| .val = 8, |
| .flags = IEEE80211_RATE_OFDM }, |
| { .rate = 360, |
| .val = 9, |
| .flags = IEEE80211_RATE_OFDM }, |
| { .rate = 480, |
| .val = 10, |
| .flags = IEEE80211_RATE_OFDM }, |
| { .rate = 540, |
| .val = 11, |
| .flags = IEEE80211_RATE_OFDM }, |
| }; |
| |
| static const struct ieee80211_channel rtl818x_channels[] = { |
| { .chan = 1, |
| .freq = 2412}, |
| { .chan = 2, |
| .freq = 2417}, |
| { .chan = 3, |
| .freq = 2422}, |
| { .chan = 4, |
| .freq = 2427}, |
| { .chan = 5, |
| .freq = 2432}, |
| { .chan = 6, |
| .freq = 2437}, |
| { .chan = 7, |
| .freq = 2442}, |
| { .chan = 8, |
| .freq = 2447}, |
| { .chan = 9, |
| .freq = 2452}, |
| { .chan = 10, |
| .freq = 2457}, |
| { .chan = 11, |
| .freq = 2462}, |
| { .chan = 12, |
| .freq = 2467}, |
| { .chan = 13, |
| .freq = 2472}, |
| { .chan = 14, |
| .freq = 2484} |
| }; |
| |
| #endif /* RTL818X_H */ |
