| /* | 
 |  * Definitions for TI EMIF device platform data | 
 |  * | 
 |  * Copyright (C) 2012 Texas Instruments, Inc. | 
 |  * | 
 |  * Aneesh V <aneesh@ti.com> | 
 |  * | 
 |  * This program is free software; you can redistribute it and/or modify | 
 |  * it under the terms of the GNU General Public License version 2 as | 
 |  * published by the Free Software Foundation. | 
 |  */ | 
 | #ifndef __EMIF_PLAT_H | 
 | #define __EMIF_PLAT_H | 
 |  | 
 | /* Low power modes - EMIF_PWR_MGMT_CTRL */ | 
 | #define EMIF_LP_MODE_DISABLE				0 | 
 | #define EMIF_LP_MODE_CLOCK_STOP				1 | 
 | #define EMIF_LP_MODE_SELF_REFRESH			2 | 
 | #define EMIF_LP_MODE_PWR_DN				4 | 
 |  | 
 | /* Hardware capabilities */ | 
 | #define	EMIF_HW_CAPS_LL_INTERFACE			0x00000001 | 
 |  | 
 | /* | 
 |  * EMIF IP Revisions | 
 |  *	EMIF4D  - Used in OMAP4 | 
 |  *	EMIF4D5 - Used in OMAP5 | 
 |  */ | 
 | #define	EMIF_4D						1 | 
 | #define	EMIF_4D5					2 | 
 |  | 
 | /* | 
 |  * PHY types | 
 |  *	ATTILAPHY  - Used in OMAP4 | 
 |  *	INTELLIPHY - Used in OMAP5 | 
 |  */ | 
 | #define	EMIF_PHY_TYPE_ATTILAPHY				1 | 
 | #define	EMIF_PHY_TYPE_INTELLIPHY			2 | 
 |  | 
 | /* Custom config requests */ | 
 | #define EMIF_CUSTOM_CONFIG_LPMODE			0x00000001 | 
 | #define EMIF_CUSTOM_CONFIG_TEMP_ALERT_POLL_INTERVAL	0x00000002 | 
 | #define EMIF_CUSTOM_CONFIG_EXTENDED_TEMP_PART		0x00000004 | 
 |  | 
 | #ifndef __ASSEMBLY__ | 
 | /** | 
 |  * struct ddr_device_info - All information about the DDR device except AC | 
 |  *		timing parameters | 
 |  * @type:	Device type (LPDDR2-S4, LPDDR2-S2 etc) | 
 |  * @density:	Device density | 
 |  * @io_width:	Bus width | 
 |  * @cs1_used:	Whether there is a DDR device attached to the second | 
 |  *		chip-select(CS1) of this EMIF instance | 
 |  * @cal_resistors_per_cs: Whether there is one calibration resistor per | 
 |  *		chip-select or whether it's a single one for both | 
 |  * @manufacturer: Manufacturer name string | 
 |  */ | 
 | struct ddr_device_info { | 
 | 	u32	type; | 
 | 	u32	density; | 
 | 	u32	io_width; | 
 | 	u32	cs1_used; | 
 | 	u32	cal_resistors_per_cs; | 
 | 	char	manufacturer[10]; | 
 | }; | 
 |  | 
 | /** | 
 |  * struct emif_custom_configs - Custom configuration parameters/policies | 
 |  *		passed from the platform layer | 
 |  * @mask:	Mask to indicate which configs are requested | 
 |  * @lpmode:	LPMODE to be used in PWR_MGMT_CTRL register | 
 |  * @lpmode_timeout_performance: Timeout before LPMODE entry when higher | 
 |  *		performance is desired at the cost of power (typically | 
 |  *		at higher OPPs) | 
 |  * @lpmode_timeout_power: Timeout before LPMODE entry when better power | 
 |  *		savings is desired and performance is not important | 
 |  *		(typically at lower loads indicated by lower OPPs) | 
 |  * @lpmode_freq_threshold: The DDR frequency threshold to identify between | 
 |  *		the above two cases: | 
 |  *		timeout = (freq >= lpmode_freq_threshold) ? | 
 |  *			lpmode_timeout_performance : | 
 |  *			lpmode_timeout_power; | 
 |  * @temp_alert_poll_interval_ms: LPDDR2 MR4 polling interval at nominal | 
 |  *		temperature(in milliseconds). When temperature is high | 
 |  *		polling is done 4 times as frequently. | 
 |  */ | 
 | struct emif_custom_configs { | 
 | 	u32 mask; | 
 | 	u32 lpmode; | 
 | 	u32 lpmode_timeout_performance; | 
 | 	u32 lpmode_timeout_power; | 
 | 	u32 lpmode_freq_threshold; | 
 | 	u32 temp_alert_poll_interval_ms; | 
 | }; | 
 |  | 
 | /** | 
 |  * struct emif_platform_data - Platform data passed on EMIF platform | 
 |  *				device creation. Used by the driver. | 
 |  * @hw_caps:		Hw capabilities of the EMIF IP in the respective SoC | 
 |  * @device_info:	Device info structure containing information such | 
 |  *			as type, bus width, density etc | 
 |  * @timings:		Timings information from device datasheet passed | 
 |  *			as an array of 'struct lpddr2_timings'. Can be NULL | 
 |  *			if if default timings are ok | 
 |  * @timings_arr_size:	Size of the timings array. Depends on the number | 
 |  *			of different frequencies for which timings data | 
 |  *			is provided | 
 |  * @min_tck:		Minimum value of some timing parameters in terms | 
 |  *			of number of cycles. Can be NULL if default values | 
 |  *			are ok | 
 |  * @custom_configs:	Custom configurations requested by SoC or board | 
 |  *			code and the data for them. Can be NULL if default | 
 |  *			configurations done by the driver are ok. See | 
 |  *			documentation for 'struct emif_custom_configs' for | 
 |  *			more details | 
 |  */ | 
 | struct emif_platform_data { | 
 | 	u32 hw_caps; | 
 | 	struct ddr_device_info *device_info; | 
 | 	const struct lpddr2_timings *timings; | 
 | 	u32 timings_arr_size; | 
 | 	const struct lpddr2_min_tck *min_tck; | 
 | 	struct emif_custom_configs *custom_configs; | 
 | 	u32 ip_rev; | 
 | 	u32 phy_type; | 
 | }; | 
 | #endif /* __ASSEMBLY__ */ | 
 |  | 
 | #endif /* __LINUX_EMIF_H */ |