| * Qualcomm Atheros ath9k wireless devices |
| |
| This node provides properties for configuring the ath9k wireless device. The |
| node is expected to be specified as a child node of the PCI controller to |
| which the wireless chip is connected. |
| |
| Required properties: |
| - compatible: For PCI and PCIe devices this should be an identifier following |
| the format as defined in "PCI Bus Binding to Open Firmware" |
| Revision 2.1. One of the possible formats is "pciVVVV,DDDD" |
| where VVVV is the PCI vendor ID and DDDD is PCI device ID. |
| Typically QCA's PCI vendor ID 168c is used while the PCI device |
| ID depends on the chipset - see the following (possibly |
| incomplete) list: |
| - 0023 for AR5416 |
| - 0024 for AR5418 |
| - 0027 for AR9160 |
| - 0029 for AR9220 and AR9223 |
| - 002a for AR9280 and AR9283 |
| - 002b for AR9285 |
| - 002c for AR2427 |
| - 002d for AR9227 |
| - 002e for AR9287 |
| - 0030 for AR9380, AR9381 and AR9382 |
| - 0032 for AR9485 |
| - 0033 for AR9580 and AR9590 |
| - 0034 for AR9462 |
| - 0036 for AR9565 |
| - 0037 for AR9485 |
| - reg: Address and length of the register set for the device. |
| |
| Optional properties: |
| - qca,no-eeprom: Indicates that there is no physical EEPROM connected to the |
| ath9k wireless chip (in this case the calibration / |
| EEPROM data will be loaded from userspace using the |
| kernel firmware loader). |
| - mac-address: See ethernet.txt in the parent directory |
| - local-mac-address: See ethernet.txt in the parent directory |
| |
| |
| In this example, the node is defined as child node of the PCI controller: |
| &pci0 { |
| wifi@168c,002d { |
| compatible = "pci168c,002d"; |
| reg = <0x7000 0 0 0 0x1000>; |
| qca,no-eeprom; |
| }; |
| }; |
