| Sitronix ST7789V RGB panel with SPI control bus | |
| Required properties: | |
| - compatible: "sitronix,st7789v" | |
| - reg: Chip select of the panel on the SPI bus | |
| - reset-gpios: a GPIO phandle for the reset pin | |
| - power-supply: phandle of the regulator that provides the supply voltage | |
| Optional properties: | |
| - backlight: phandle to the backlight used | |
| The generic bindings for the SPI slaves documented in [1] also applies | |
| The device node can contain one 'port' child node with one child | |
| 'endpoint' node, according to the bindings defined in [2]. This | |
| node should describe panel's video bus. | |
| [1]: Documentation/devicetree/bindings/spi/spi-bus.txt | |
| [2]: Documentation/devicetree/bindings/graph.txt | |
| Example: | |
| panel@0 { | |
| compatible = "sitronix,st7789v"; | |
| reg = <0>; | |
| reset-gpios = <&pio 6 11 GPIO_ACTIVE_LOW>; | |
| backlight = <&pwm_bl>; | |
| spi-max-frequency = <100000>; | |
| spi-cpol; | |
| spi-cpha; | |
| port { | |
| panel_input: endpoint { | |
| remote-endpoint = <&tcon0_out_panel>; | |
| }; | |
| }; | |
| }; |