blob: c59f4581e97271cc35d07bed98876d300384fa9c [file] [log] [blame]
/******************************************************************************
*
* This file is provided under a dual BSD/GPLv2 license. When using or
* redistributing this file, you may do so under either license.
*
* GPL LICENSE SUMMARY
*
* Copyright(c) 2017 Intel Deutschland GmbH
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of version 2 of the GNU General Public License as
* published by the Free Software Foundation.
*
* This program is distributed in the hope that it will be useful, but
* WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU
* General Public License for more details.
*
* BSD LICENSE
*
* Copyright(c) 2017 Intel Deutschland GmbH
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
*
* * Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* * Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in
* the documentation and/or other materials provided with the
* distribution.
* * Neither the name Intel Corporation nor the names of its
* contributors may be used to endorse or promote products derived
* from this software without specific prior written permission.
*
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
* "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
* LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
* A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
* OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
* SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
* LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
* DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
* THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
* (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
* OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
*
*****************************************************************************/
#include "iwl-trans.h"
#include "iwl-context-info.h"
#include "internal.h"
/*
* Start up NIC's basic functionality after it has been reset
* (e.g. after platform boot, or shutdown via iwl_pcie_apm_stop())
* NOTE: This does not load uCode nor start the embedded processor
*/
static int iwl_pcie_gen2_apm_init(struct iwl_trans *trans)
{
int ret = 0;
IWL_DEBUG_INFO(trans, "Init card's basic functions\n");
/*
* Use "set_bit" below rather than "write", to preserve any hardware
* bits already set by default after reset.
*/
/*
* Disable L0s without affecting L1;
* don't wait for ICH L0s (ICH bug W/A)
*/
iwl_set_bit(trans, CSR_GIO_CHICKEN_BITS,
CSR_GIO_CHICKEN_BITS_REG_BIT_L1A_NO_L0S_RX);
/* Set FH wait threshold to maximum (HW error during stress W/A) */
iwl_set_bit(trans, CSR_DBG_HPET_MEM_REG, CSR_DBG_HPET_MEM_REG_VAL);
/*
* Enable HAP INTA (interrupt from management bus) to
* wake device's PCI Express link L1a -> L0s
*/
iwl_set_bit(trans, CSR_HW_IF_CONFIG_REG,
CSR_HW_IF_CONFIG_REG_BIT_HAP_WAKE_L1A);
iwl_pcie_apm_config(trans);
/*
* Set "initialization complete" bit to move adapter from
* D0U* --> D0A* (powered-up active) state.
*/
iwl_set_bit(trans, CSR_GP_CNTRL, CSR_GP_CNTRL_REG_FLAG_INIT_DONE);
/*
* Wait for clock stabilization; once stabilized, access to
* device-internal resources is supported, e.g. iwl_write_prph()
* and accesses to uCode SRAM.
*/
ret = iwl_poll_bit(trans, CSR_GP_CNTRL,
CSR_GP_CNTRL_REG_FLAG_MAC_CLOCK_READY,
CSR_GP_CNTRL_REG_FLAG_MAC_CLOCK_READY, 25000);
if (ret < 0) {
IWL_DEBUG_INFO(trans, "Failed to init the card\n");
return ret;
}
set_bit(STATUS_DEVICE_ENABLED, &trans->status);
return 0;
}
static void iwl_pcie_gen2_apm_stop(struct iwl_trans *trans, bool op_mode_leave)
{
IWL_DEBUG_INFO(trans, "Stop card, put in low power state\n");
if (op_mode_leave) {
if (!test_bit(STATUS_DEVICE_ENABLED, &trans->status))
iwl_pcie_gen2_apm_init(trans);
/* inform ME that we are leaving */
iwl_set_bit(trans, CSR_DBG_LINK_PWR_MGMT_REG,
CSR_RESET_LINK_PWR_MGMT_DISABLED);
iwl_set_bit(trans, CSR_HW_IF_CONFIG_REG,
CSR_HW_IF_CONFIG_REG_PREPARE |
CSR_HW_IF_CONFIG_REG_ENABLE_PME);
mdelay(1);
iwl_clear_bit(trans, CSR_DBG_LINK_PWR_MGMT_REG,
CSR_RESET_LINK_PWR_MGMT_DISABLED);
mdelay(5);
}
clear_bit(STATUS_DEVICE_ENABLED, &trans->status);
/* Stop device's DMA activity */
iwl_pcie_apm_stop_master(trans);
iwl_pcie_sw_reset(trans);
/*
* Clear "initialization complete" bit to move adapter from
* D0A* (powered-up Active) --> D0U* (Uninitialized) state.
*/
iwl_clear_bit(trans, CSR_GP_CNTRL, CSR_GP_CNTRL_REG_FLAG_INIT_DONE);
}
void _iwl_trans_pcie_gen2_stop_device(struct iwl_trans *trans, bool low_power)
{
struct iwl_trans_pcie *trans_pcie = IWL_TRANS_GET_PCIE_TRANS(trans);
lockdep_assert_held(&trans_pcie->mutex);
if (trans_pcie->is_down)
return;
trans_pcie->is_down = true;
/* tell the device to stop sending interrupts */
iwl_disable_interrupts(trans);
/* device going down, Stop using ICT table */
iwl_pcie_disable_ict(trans);
/*
* If a HW restart happens during firmware loading,
* then the firmware loading might call this function
* and later it might be called again due to the
* restart. So don't process again if the device is
* already dead.
*/
if (test_and_clear_bit(STATUS_DEVICE_ENABLED, &trans->status)) {
IWL_DEBUG_INFO(trans,
"DEVICE_ENABLED bit was set and is now cleared\n");
iwl_pcie_gen2_tx_stop(trans);
iwl_pcie_rx_stop(trans);
}
iwl_pcie_ctxt_info_free_paging(trans);
iwl_pcie_ctxt_info_free(trans);
/* Make sure (redundant) we've released our request to stay awake */
iwl_clear_bit(trans, CSR_GP_CNTRL,
CSR_GP_CNTRL_REG_FLAG_MAC_ACCESS_REQ);
/* Stop the device, and put it in low power state */
iwl_pcie_gen2_apm_stop(trans, false);
iwl_pcie_sw_reset(trans);
/*
* Upon stop, the IVAR table gets erased, so msi-x won't
* work. This causes a bug in RF-KILL flows, since the interrupt
* that enables radio won't fire on the correct irq, and the
* driver won't be able to handle the interrupt.
* Configure the IVAR table again after reset.
*/
iwl_pcie_conf_msix_hw(trans_pcie);
/*
* Upon stop, the APM issues an interrupt if HW RF kill is set.
* This is a bug in certain verions of the hardware.
* Certain devices also keep sending HW RF kill interrupt all
* the time, unless the interrupt is ACKed even if the interrupt
* should be masked. Re-ACK all the interrupts here.
*/
iwl_disable_interrupts(trans);
/* clear all status bits */
clear_bit(STATUS_SYNC_HCMD_ACTIVE, &trans->status);
clear_bit(STATUS_INT_ENABLED, &trans->status);
clear_bit(STATUS_TPOWER_PMI, &trans->status);
/*
* Even if we stop the HW, we still want the RF kill
* interrupt
*/
iwl_enable_rfkill_int(trans);
/* re-take ownership to prevent other users from stealing the device */
iwl_pcie_prepare_card_hw(trans);
}
void iwl_trans_pcie_gen2_stop_device(struct iwl_trans *trans, bool low_power)
{
struct iwl_trans_pcie *trans_pcie = IWL_TRANS_GET_PCIE_TRANS(trans);
bool was_in_rfkill;
mutex_lock(&trans_pcie->mutex);
trans_pcie->opmode_down = true;
was_in_rfkill = test_bit(STATUS_RFKILL_OPMODE, &trans->status);
_iwl_trans_pcie_gen2_stop_device(trans, low_power);
iwl_trans_pcie_handle_stop_rfkill(trans, was_in_rfkill);
mutex_unlock(&trans_pcie->mutex);
}
static int iwl_pcie_gen2_nic_init(struct iwl_trans *trans)
{
struct iwl_trans_pcie *trans_pcie = IWL_TRANS_GET_PCIE_TRANS(trans);
/* TODO: most of the logic can be removed in A0 - but not in Z0 */
spin_lock(&trans_pcie->irq_lock);
iwl_pcie_gen2_apm_init(trans);
spin_unlock(&trans_pcie->irq_lock);
iwl_op_mode_nic_config(trans->op_mode);
/* Allocate the RX queue, or reset if it is already allocated */
if (iwl_pcie_gen2_rx_init(trans))
return -ENOMEM;
/* Allocate or reset and init all Tx and Command queues */
if (iwl_pcie_gen2_tx_init(trans))
return -ENOMEM;
/* enable shadow regs in HW */
iwl_set_bit(trans, CSR_MAC_SHADOW_REG_CTRL, 0x800FFFFF);
IWL_DEBUG_INFO(trans, "Enabling shadow registers in device\n");
return 0;
}
void iwl_trans_pcie_gen2_fw_alive(struct iwl_trans *trans, u32 scd_addr)
{
struct iwl_trans_pcie *trans_pcie = IWL_TRANS_GET_PCIE_TRANS(trans);
iwl_pcie_reset_ict(trans);
/* make sure all queue are not stopped/used */
memset(trans_pcie->queue_stopped, 0, sizeof(trans_pcie->queue_stopped));
memset(trans_pcie->queue_used, 0, sizeof(trans_pcie->queue_used));
/* now that we got alive we can free the fw image & the context info.
* paging memory cannot be freed included since FW will still use it
*/
iwl_pcie_ctxt_info_free(trans);
}
int iwl_trans_pcie_gen2_start_fw(struct iwl_trans *trans,
const struct fw_img *fw, bool run_in_rfkill)
{
struct iwl_trans_pcie *trans_pcie = IWL_TRANS_GET_PCIE_TRANS(trans);
bool hw_rfkill;
int ret;
/* This may fail if AMT took ownership of the device */
if (iwl_pcie_prepare_card_hw(trans)) {
IWL_WARN(trans, "Exit HW not ready\n");
ret = -EIO;
goto out;
}
iwl_enable_rfkill_int(trans);
iwl_write32(trans, CSR_INT, 0xFFFFFFFF);
/*
* We enabled the RF-Kill interrupt and the handler may very
* well be running. Disable the interrupts to make sure no other
* interrupt can be fired.
*/
iwl_disable_interrupts(trans);
/* Make sure it finished running */
iwl_pcie_synchronize_irqs(trans);
mutex_lock(&trans_pcie->mutex);
/* If platform's RF_KILL switch is NOT set to KILL */
hw_rfkill = iwl_pcie_check_hw_rf_kill(trans);
if (hw_rfkill && !run_in_rfkill) {
ret = -ERFKILL;
goto out;
}
/* Someone called stop_device, don't try to start_fw */
if (trans_pcie->is_down) {
IWL_WARN(trans,
"Can't start_fw since the HW hasn't been started\n");
ret = -EIO;
goto out;
}
/* make sure rfkill handshake bits are cleared */
iwl_write32(trans, CSR_UCODE_DRV_GP1_CLR, CSR_UCODE_SW_BIT_RFKILL);
iwl_write32(trans, CSR_UCODE_DRV_GP1_CLR,
CSR_UCODE_DRV_GP1_BIT_CMD_BLOCKED);
/* clear (again), then enable host interrupts */
iwl_write32(trans, CSR_INT, 0xFFFFFFFF);
ret = iwl_pcie_gen2_nic_init(trans);
if (ret) {
IWL_ERR(trans, "Unable to init nic\n");
goto out;
}
ret = iwl_pcie_ctxt_info_init(trans, fw);
if (ret)
goto out;
/* re-check RF-Kill state since we may have missed the interrupt */
hw_rfkill = iwl_pcie_check_hw_rf_kill(trans);
if (hw_rfkill && !run_in_rfkill)
ret = -ERFKILL;
out:
mutex_unlock(&trans_pcie->mutex);
return ret;
}