| #ifndef DIBX000_COMMON_H | |
| #define DIBX000_COMMON_H | |
| enum dibx000_i2c_interface { | |
| DIBX000_I2C_INTERFACE_TUNER = 0, | |
| DIBX000_I2C_INTERFACE_GPIO_1_2 = 1, | |
| DIBX000_I2C_INTERFACE_GPIO_3_4 = 2 | |
| }; | |
| struct dibx000_i2c_master { | |
| #define DIB3000MC 1 | |
| #define DIB7000 2 | |
| #define DIB7000P 11 | |
| #define DIB7000MC 12 | |
| u16 device_rev; | |
| enum dibx000_i2c_interface selected_interface; | |
| // struct i2c_adapter tuner_i2c_adap; | |
| struct i2c_adapter gated_tuner_i2c_adap; | |
| struct i2c_adapter *i2c_adap; | |
| u8 i2c_addr; | |
| u16 base_reg; | |
| }; | |
| extern int dibx000_init_i2c_master(struct dibx000_i2c_master *mst, u16 device_rev, struct i2c_adapter *i2c_adap, u8 i2c_addr); | |
| extern struct i2c_adapter * dibx000_get_i2c_adapter(struct dibx000_i2c_master *mst, enum dibx000_i2c_interface intf, int gating); | |
| extern void dibx000_exit_i2c_master(struct dibx000_i2c_master *mst); | |
| #define BAND_LBAND 0x01 | |
| #define BAND_UHF 0x02 | |
| #define BAND_VHF 0x04 | |
| struct dibx000_agc_config { | |
| /* defines the capabilities of this AGC-setting - using the BAND_-defines*/ | |
| u8 band_caps; | |
| u16 setup; | |
| u16 inv_gain; | |
| u16 time_stabiliz; | |
| u8 alpha_level; | |
| u16 thlock; | |
| u8 wbd_inv; | |
| u16 wbd_ref; | |
| u8 wbd_sel; | |
| u8 wbd_alpha; | |
| u16 agc1_max; | |
| u16 agc1_min; | |
| u16 agc2_max; | |
| u16 agc2_min; | |
| u8 agc1_pt1; | |
| u8 agc1_pt2; | |
| u8 agc1_pt3; | |
| u8 agc1_slope1; | |
| u8 agc1_slope2; | |
| u8 agc2_pt1; | |
| u8 agc2_pt2; | |
| u8 agc2_slope1; | |
| u8 agc2_slope2; | |
| u8 alpha_mant; | |
| u8 alpha_exp; | |
| u8 beta_mant; | |
| u8 beta_exp; | |
| u8 perform_agc_softsplit; | |
| struct { | |
| u16 min; | |
| u16 max; | |
| u16 min_thres; | |
| u16 max_thres; | |
| } split; | |
| }; | |
| struct dibx000_bandwidth_config { | |
| u32 internal; | |
| u32 sampling; | |
| u8 pll_prediv; | |
| u8 pll_ratio; | |
| u8 pll_range; | |
| u8 pll_reset; | |
| u8 pll_bypass; | |
| u8 enable_refdiv; | |
| u8 bypclk_div; | |
| u8 IO_CLK_en_core; | |
| u8 ADClkSrc; | |
| u8 modulo; | |
| u16 sad_cfg; | |
| u32 ifreq; | |
| u32 timf; | |
| }; | |
| enum dibx000_adc_states { | |
| DIBX000_SLOW_ADC_ON = 0, | |
| DIBX000_SLOW_ADC_OFF, | |
| DIBX000_ADC_ON, | |
| DIBX000_ADC_OFF, | |
| DIBX000_VBG_ENABLE, | |
| DIBX000_VBG_DISABLE, | |
| }; | |
| #define BW_INDEX_TO_KHZ(v) ( (v) == BANDWIDTH_8_MHZ ? 8000 : \ | |
| (v) == BANDWIDTH_7_MHZ ? 7000 : \ | |
| (v) == BANDWIDTH_6_MHZ ? 6000 : 8000 ) | |
| /* Chip output mode. */ | |
| #define OUTMODE_HIGH_Z 0 | |
| #define OUTMODE_MPEG2_PAR_GATED_CLK 1 | |
| #define OUTMODE_MPEG2_PAR_CONT_CLK 2 | |
| #define OUTMODE_MPEG2_SERIAL 7 | |
| #define OUTMODE_DIVERSITY 4 | |
| #define OUTMODE_MPEG2_FIFO 5 | |
| /* I hope I can get rid of the following kludge in the near future */ | |
| struct dibx000_ofdm_channel { | |
| u8 Bw; | |
| s16 nfft; | |
| s16 guard; | |
| s16 nqam; | |
| s16 vit_hrch; | |
| s16 vit_select_hp; | |
| s16 vit_alpha; | |
| s16 vit_code_rate_hp; | |
| s16 vit_code_rate_lp; | |
| }; | |
| #define FEP2DIB(fep,ch) \ | |
| (ch)->Bw = (fep)->u.ofdm.bandwidth; \ | |
| (ch)->nfft = (fep)->u.ofdm.transmission_mode == TRANSMISSION_MODE_AUTO ? -1 : (fep)->u.ofdm.transmission_mode; \ | |
| (ch)->guard = (fep)->u.ofdm.guard_interval == GUARD_INTERVAL_AUTO ? -1 : (fep)->u.ofdm.guard_interval; \ | |
| (ch)->nqam = (fep)->u.ofdm.constellation == QAM_AUTO ? -1 : (fep)->u.ofdm.constellation == QAM_64 ? 2 : (fep)->u.ofdm.constellation; \ | |
| (ch)->vit_hrch = 0; /* linux-dvb is not prepared for HIERARCHICAL TRANSMISSION */ \ | |
| (ch)->vit_select_hp = 1; \ | |
| (ch)->vit_alpha = 1; \ | |
| (ch)->vit_code_rate_hp = (fep)->u.ofdm.code_rate_HP == FEC_AUTO ? -1 : (fep)->u.ofdm.code_rate_HP; \ | |
| (ch)->vit_code_rate_lp = (fep)->u.ofdm.code_rate_LP == FEC_AUTO ? -1 : (fep)->u.ofdm.code_rate_LP; | |
| #define INIT_OFDM_CHANNEL(ch) do {\ | |
| (ch)->Bw = 0; \ | |
| (ch)->nfft = -1; \ | |
| (ch)->guard = -1; \ | |
| (ch)->nqam = -1; \ | |
| (ch)->vit_hrch = -1; \ | |
| (ch)->vit_select_hp = -1; \ | |
| (ch)->vit_alpha = -1; \ | |
| (ch)->vit_code_rate_hp = -1; \ | |
| (ch)->vit_code_rate_lp = -1; \ | |
| } while (0) | |
| #endif |