| #ifndef _ACI_H_ | |
| #define _ACI_H_ | |
| extern int aci_port; | |
| extern int aci_version; /* ACI firmware version */ | |
| extern int aci_rw_cmd(int write1, int write2, int write3); | |
| #define aci_indexed_cmd(a, b) aci_rw_cmd(a, b, -1) | |
| #define aci_write_cmd(a, b) aci_rw_cmd(a, b, -1) | |
| #define aci_read_cmd(a) aci_rw_cmd(a,-1, -1) | |
| #define COMMAND_REGISTER (aci_port) /* write register */ | |
| #define STATUS_REGISTER (aci_port + 1) /* read register */ | |
| #define BUSY_REGISTER (aci_port + 2) /* also used for rds */ | |
| #define RDS_REGISTER BUSY_REGISTER | |
| #define ACI_SET_MUTE 0x0d | |
| #define ACI_SET_POWERAMP 0x0f | |
| #define ACI_SET_TUNERMUTE 0xa3 | |
| #define ACI_SET_TUNERMONO 0xa4 | |
| #define ACI_SET_IDE 0xd0 | |
| #define ACI_SET_WSS 0xd1 | |
| #define ACI_SET_SOLOMODE 0xd2 | |
| #define ACI_WRITE_IGAIN 0x03 | |
| #define ACI_WRITE_TUNE 0xa7 | |
| #define ACI_READ_TUNERSTEREO 0xa8 | |
| #define ACI_READ_TUNERSTATION 0xa9 | |
| #define ACI_READ_VERSION 0xf1 | |
| #define ACI_READ_IDCODE 0xf2 | |
| #define ACI_INIT 0xff | |
| #define ACI_STATUS 0xf0 | |
| #define ACI_S_GENERAL 0x00 | |
| #define ACI_S_READ_IGAIN 0x21 | |
| #define ACI_ERROR_OP 0xdf | |
| /* | |
| * The following macro SCALE can be used to scale one integer volume | |
| * value into another one using only integer arithmetic. If the input | |
| * value x is in the range 0 <= x <= xmax, then the result will be in | |
| * the range 0 <= SCALE(xmax,ymax,x) <= ymax. | |
| * | |
| * This macro has for all xmax, ymax > 0 and all 0 <= x <= xmax the | |
| * following nice properties: | |
| * | |
| * - SCALE(xmax,ymax,xmax) = ymax | |
| * - SCALE(xmax,ymax,0) = 0 | |
| * - SCALE(xmax,ymax,SCALE(ymax,xmax,SCALE(xmax,ymax,x))) = SCALE(xmax,ymax,x) | |
| * | |
| * In addition, the rounding error is minimal and nicely distributed. | |
| * The proofs are left as an exercise to the reader. | |
| */ | |
| #define SCALE(xmax,ymax,x) (((x)*(ymax)+(xmax)/2)/(xmax)) | |
| #endif /* _ACI_H_ */ |