| * Allwinner A10 Codec |
| |
| Required properties: |
| - compatible: must be one of the following compatibles: |
| - "allwinner,sun4i-a10-codec" |
| - "allwinner,sun6i-a31-codec" |
| - "allwinner,sun7i-a20-codec" |
| - "allwinner,sun8i-a23-codec" |
| - "allwinner,sun8i-h3-codec" |
| - "allwinner,sun8i-v3s-codec" |
| - reg: must contain the registers location and length |
| - interrupts: must contain the codec interrupt |
| - dmas: DMA channels for tx and rx dma. See the DMA client binding, |
| Documentation/devicetree/bindings/dma/dma.txt |
| - dma-names: should include "tx" and "rx". |
| - clocks: a list of phandle + clock-specifer pairs, one for each entry |
| in clock-names. |
| - clock-names: should contain the following: |
| - "apb": the parent APB clock for this controller |
| - "codec": the parent module clock |
| |
| Optional properties: |
| - allwinner,pa-gpios: gpio to enable external amplifier |
| |
| Required properties for the following compatibles: |
| - "allwinner,sun6i-a31-codec" |
| - "allwinner,sun8i-a23-codec" |
| - "allwinner,sun8i-h3-codec" |
| - "allwinner,sun8i-v3s-codec" |
| - resets: phandle to the reset control for this device |
| - allwinner,audio-routing: A list of the connections between audio components. |
| Each entry is a pair of strings, the first being the |
| connection's sink, the second being the connection's |
| source. Valid names include: |
| |
| Audio pins on the SoC: |
| "HP" |
| "HPCOM" |
| "LINEIN" (not on sun8i-v3s) |
| "LINEOUT" (not on sun8i-a23 or sun8i-v3s) |
| "MIC1" |
| "MIC2" (not on sun8i-v3s) |
| "MIC3" (sun6i-a31 only) |
| |
| Microphone biases from the SoC: |
| "HBIAS" |
| "MBIAS" (not on sun8i-v3s) |
| |
| Board connectors: |
| "Headphone" |
| "Headset Mic" |
| "Line In" |
| "Line Out" |
| "Mic" |
| "Speaker" |
| |
| Required properties for the following compatibles: |
| - "allwinner,sun8i-a23-codec" |
| - "allwinner,sun8i-h3-codec" |
| - "allwinner,sun8i-v3s-codec" |
| - allwinner,codec-analog-controls: A phandle to the codec analog controls |
| block in the PRCM. |
| |
| Example: |
| codec: codec@01c22c00 { |
| #sound-dai-cells = <0>; |
| compatible = "allwinner,sun7i-a20-codec"; |
| reg = <0x01c22c00 0x40>; |
| interrupts = <0 30 4>; |
| clocks = <&apb0_gates 0>, <&codec_clk>; |
| clock-names = "apb", "codec"; |
| dmas = <&dma 0 19>, <&dma 0 19>; |
| dma-names = "rx", "tx"; |
| }; |
| |
| codec: codec@01c22c00 { |
| #sound-dai-cells = <0>; |
| compatible = "allwinner,sun6i-a31-codec"; |
| reg = <0x01c22c00 0x98>; |
| interrupts = <GIC_SPI 29 IRQ_TYPE_LEVEL_HIGH>; |
| clocks = <&ccu CLK_APB1_CODEC>, <&ccu CLK_CODEC>; |
| clock-names = "apb", "codec"; |
| resets = <&ccu RST_APB1_CODEC>; |
| dmas = <&dma 15>, <&dma 15>; |
| dma-names = "rx", "tx"; |
| allwinner,audio-routing = |
| "Headphone", "HP", |
| "Speaker", "LINEOUT", |
| "LINEIN", "Line In", |
| "MIC1", "MBIAS", |
| "MIC1", "Mic", |
| "MIC2", "HBIAS", |
| "MIC2", "Headset Mic"; |
| }; |