KVM: x86: Update APICv on APIC reset
In kvm_apic_set_state() we update the hardware virtualized APIC after
the full APIC state has been overwritten. Do the same, when the full
APIC state has been reset in kvm_lapic_reset().
This updates some hardware state that was previously forgotten, as
far as I can tell. Also, this allows removing some APIC-related reset
code from vmx_vcpu_reset().
Signed-off-by: Jan H. Schönherr <jschoenh@amazon.de>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
diff --git a/arch/x86/kvm/lapic.c b/arch/x86/kvm/lapic.c
index 69c5612..36c90d6 100644
--- a/arch/x86/kvm/lapic.c
+++ b/arch/x86/kvm/lapic.c
@@ -1992,6 +1992,11 @@
vcpu->arch.apic_base | MSR_IA32_APICBASE_BSP);
vcpu->arch.pv_eoi.msr_val = 0;
apic_update_ppr(apic);
+ if (vcpu->arch.apicv_active) {
+ kvm_x86_ops->apicv_post_state_restore(vcpu);
+ kvm_x86_ops->hwapic_irr_update(vcpu, -1);
+ kvm_x86_ops->hwapic_isr_update(vcpu, -1);
+ }
vcpu->arch.apic_arb_prio = 0;
vcpu->arch.apic_attention = 0;
diff --git a/arch/x86/kvm/vmx.c b/arch/x86/kvm/vmx.c
index e0b4b64..a6f4f09 100644
--- a/arch/x86/kvm/vmx.c
+++ b/arch/x86/kvm/vmx.c
@@ -5619,11 +5619,6 @@
kvm_make_request(KVM_REQ_APIC_PAGE_RELOAD, vcpu);
- if (kvm_vcpu_apicv_active(vcpu)) {
- pi_clear_on(&vmx->pi_desc);
- memset(vmx->pi_desc.pir, 0, sizeof(vmx->pi_desc.pir));
- }
-
if (vmx->vpid != 0)
vmcs_write16(VIRTUAL_PROCESSOR_ID, vmx->vpid);
