blob: ec19fbf928a142db6d9e853fee7e98f1e31d66b2 [file] [log] [blame]
/*
* BSD LICENSE
*
* Copyright(c) 2015 Broadcom Corporation. All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
*
* * Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* * Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in
* the documentation and/or other materials provided with the
* distribution.
* * Neither the name of Broadcom Corporation nor the names of its
* contributors may be used to endorse or promote products derived
* from this software without specific prior written permission.
*
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
* "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
* LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
* A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
* OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
* SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
* LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
* DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
* THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
* (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
* OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
*/
/dts-v1/;
#include "ns2.dtsi"
/ {
model = "Broadcom NS2 SVK";
compatible = "brcm,ns2-svk", "brcm,ns2";
aliases {
serial0 = &uart3;
serial1 = &uart0;
serial2 = &uart1;
serial3 = &uart2;
};
chosen {
stdout-path = "serial0:115200n8";
bootargs = "earlycon=uart8250,mmio32,0x66130000";
};
memory {
device_type = "memory";
reg = <0x000000000 0x80000000 0x00000000 0x40000000>;
};
};
&enet {
status = "okay";
};
&pci_phy0 {
status = "okay";
};
&pci_phy1 {
status = "okay";
};
&pcie0 {
status = "okay";
};
&pcie4 {
status = "okay";
};
&pcie8 {
status = "okay";
};
&i2c0 {
status = "okay";
};
&i2c1 {
status = "okay";
};
&uart0 {
status = "okay";
};
&uart1 {
status = "okay";
};
&uart2 {
status = "okay";
};
&uart3 {
status = "okay";
};
&ssp0 {
status = "okay";
slic@0 {
compatible = "silabs,si3226x";
reg = <0>;
spi-max-frequency = <5000000>;
spi-cpha = <1>;
spi-cpol = <1>;
pl022,hierarchy = <0>;
pl022,interface = <0>;
pl022,slave-tx-disable = <0>;
pl022,com-mode = <0>;
pl022,rx-level-trig = <1>;
pl022,tx-level-trig = <1>;
pl022,ctrl-len = <11>;
pl022,wait-state = <0>;
pl022,duplex = <0>;
};
};
&ssp1 {
status = "okay";
at25@0 {
compatible = "atmel,at25";
reg = <0>;
spi-max-frequency = <5000000>;
at25,byte-len = <0x8000>;
at25,addr-mode = <2>;
at25,page-size = <64>;
spi-cpha = <1>;
spi-cpol = <1>;
pl022,hierarchy = <0>;
pl022,interface = <0>;
pl022,slave-tx-disable = <0>;
pl022,com-mode = <0>;
pl022,rx-level-trig = <1>;
pl022,tx-level-trig = <1>;
pl022,ctrl-len = <11>;
pl022,wait-state = <0>;
pl022,duplex = <0>;
};
};
&sata_phy0 {
status = "okay";
};
&sata_phy1 {
status = "okay";
};
&sata {
status = "okay";
};
&sdio0 {
status = "okay";
};
&sdio1 {
status = "okay";
};
&nand {
nandcs@0 {
compatible = "brcm,nandcs";
reg = <0>;
nand-ecc-mode = "hw";
nand-ecc-strength = <8>;
nand-ecc-step-size = <512>;
nand-bus-width = <16>;
brcm,nand-oob-sector-size = <16>;
#address-cells = <1>;
#size-cells = <1>;
};
};
&mdio_mux_iproc {
mdio@10 {
gphy0: eth-phy@10 {
enet-phy-lane-swap;
reg = <0x10>;
};
};
};
&pinctrl {
pinctrl-names = "default";
pinctrl-0 = <&nand_sel>;
nand_sel: nand_sel {
function = "nand";
groups = "nand_grp";
};
};
&qspi {
bspi-sel = <0>;
flash: m25p80@0 {
#address-cells = <1>;
#size-cells = <1>;
compatible = "m25p80";
reg = <0x0>;
spi-max-frequency = <12500000>;
m25p,fast-read;
spi-cpol;
spi-cpha;
partition@0 {
label = "boot";
reg = <0x00000000 0x000a0000>;
};
partition@a0000 {
label = "env";
reg = <0x000a0000 0x00060000>;
};
partition@100000 {
label = "system";
reg = <0x00100000 0x00600000>;
};
partition@700000 {
label = "rootfs";
reg = <0x00700000 0x01900000>;
};
};
};