blob: aa0fcb05acb3e4d309224f21fff291c71a6286e9 [file] [log] [blame]
Qualcomm QUSB2 phy controller
=============================
QUSB2 controller supports LS/FS/HS usb connectivity on Qualcomm chipsets.
Required properties:
- compatible: compatible list, contains "qcom,msm8996-qusb2-phy".
- reg: offset and length of the PHY register set.
- #phy-cells: must be 0.
- clocks: a list of phandles and clock-specifier pairs,
one for each entry in clock-names.
- clock-names: must be "cfg_ahb" for phy config clock,
"ref" for 19.2 MHz ref clk,
"iface" for phy interface clock (Optional).
- vdda-pll-supply: Phandle to 1.8V regulator supply to PHY refclk pll block.
- vdda-phy-dpdm-supply: Phandle to 3.1V regulator supply to Dp/Dm port signals.
- resets: Phandle to reset to phy block.
Optional properties:
- nvmem-cells: Phandle to nvmem cell that contains 'HS Tx trim'
tuning parameter value for qusb2 phy.
- qcom,tcsr-syscon: Phandle to TCSR syscon register region.
Example:
hsusb_phy: phy@7411000 {
compatible = "qcom,msm8996-qusb2-phy";
reg = <0x7411000 0x180>;
#phy-cells = <0>;
clocks = <&gcc GCC_USB_PHY_CFG_AHB2PHY_CLK>,
<&gcc GCC_RX1_USB2_CLKREF_CLK>,
clock-names = "cfg_ahb", "ref";
vdda-pll-supply = <&pm8994_l12>;
vdda-phy-dpdm-supply = <&pm8994_l24>;
resets = <&gcc GCC_QUSB2PHY_PRIM_BCR>;
nvmem-cells = <&qusb2p_hstx_trim>;
};