| /* | |
| * O2D base Device Tree Source | |
| * | |
| * Copyright (C) 2012 DENX Software Engineering | |
| * Anatolij Gustschin <agust@denx.de> | |
| * | |
| * This program is free software; you can redistribute it and/or modify it | |
| * under the terms of the GNU General Public License as published by the | |
| * Free Software Foundation; either version 2 of the License, or (at your | |
| * option) any later version. | |
| */ | |
| /include/ "mpc5200b.dtsi" | |
| &gpt0 { | |
| gpio-controller; | |
| fsl,has-wdt; | |
| fsl,wdt-on-boot = <0>; | |
| }; | |
| &gpt1 { gpio-controller; }; | |
| / { | |
| model = "ifm,o2d"; | |
| compatible = "ifm,o2d"; | |
| memory { | |
| reg = <0x00000000 0x04000000>; // 64MB | |
| }; | |
| soc5200@f0000000 { | |
| rtc@800 { | |
| status = "disabled"; | |
| }; | |
| psc@2000 { // PSC1 | |
| compatible = "fsl,mpc5200b-psc-spi","fsl,mpc5200-psc-spi"; | |
| #address-cells = <1>; | |
| #size-cells = <0>; | |
| cell-index = <0>; | |
| spidev@0 { | |
| compatible = "spidev"; | |
| spi-max-frequency = <250000>; | |
| reg = <0>; | |
| }; | |
| }; | |
| psc@2200 { // PSC2 | |
| status = "disabled"; | |
| }; | |
| psc@2400 { // PSC3 | |
| status = "disabled"; | |
| }; | |
| psc@2600 { // PSC4 | |
| compatible = "fsl,mpc5200b-psc-uart","fsl,mpc5200-psc-uart"; | |
| }; | |
| psc@2800 { // PSC5 | |
| compatible = "fsl,mpc5200b-psc-uart","fsl,mpc5200-psc-uart"; | |
| }; | |
| psc@2c00 { // PSC6 | |
| status = "disabled"; | |
| }; | |
| ethernet@3000 { | |
| phy-handle = <&phy0>; | |
| }; | |
| mdio@3000 { | |
| phy0: ethernet-phy@0 { | |
| reg = <0>; | |
| }; | |
| }; | |
| }; | |
| localbus { | |
| ranges = <0 0 0xff000000 0x01000000 | |
| 3 0 0xe3000000 0x00100000>; | |
| // flash device at LocalPlus Bus CS0 | |
| flash@0,0 { | |
| compatible = "cfi-flash"; | |
| reg = <0 0 0x01000000>; | |
| bank-width = <1>; | |
| device-width = <2>; | |
| #size-cells = <1>; | |
| #address-cells = <1>; | |
| no-unaligned-direct-access; | |
| /* common layout for all machines */ | |
| partition@0 { | |
| label = "u-boot"; | |
| reg = <0x00000000 0x00040000>; | |
| read-only; | |
| }; | |
| partition@40000 { | |
| label = "env"; | |
| reg = <0x00040000 0x00020000>; | |
| read-only; | |
| }; | |
| }; | |
| csi@3,0 { | |
| compatible = "ifm,o2d-csi"; | |
| reg = <3 0 0x00100000>; | |
| ifm,csi-clk-handle = <&gpt7>; | |
| gpios = <&gpio_simple 23 0 /* imag_capture */ | |
| &gpio_simple 26 0 /* imag_reset */ | |
| &gpio_simple 29 0>; /* imag_master_en */ | |
| interrupts = <1 1 2>; /* IRQ1, edge falling */ | |
| ifm,csi-addr-bus-width = <24>; | |
| ifm,csi-data-bus-width = <8>; | |
| ifm,csi-wait-cycles = <0>; | |
| }; | |
| }; | |
| }; |