| /* $Date: 2005/03/07 23:59:05 $ $RCSfile: mv88e1xxx.h,v $ $Revision: 1.13 $ */ | |
| #ifndef CHELSIO_MV8E1XXX_H | |
| #define CHELSIO_MV8E1XXX_H | |
| #ifndef BMCR_SPEED1000 | |
| # define BMCR_SPEED1000 0x40 | |
| #endif | |
| #ifndef ADVERTISE_PAUSE | |
| # define ADVERTISE_PAUSE 0x400 | |
| #endif | |
| #ifndef ADVERTISE_PAUSE_ASYM | |
| # define ADVERTISE_PAUSE_ASYM 0x800 | |
| #endif | |
| /* Gigabit MII registers */ | |
| #define MII_GBCR 9 /* 1000Base-T control register */ | |
| #define MII_GBSR 10 /* 1000Base-T status register */ | |
| /* 1000Base-T control register fields */ | |
| #define GBCR_ADV_1000HALF 0x100 | |
| #define GBCR_ADV_1000FULL 0x200 | |
| #define GBCR_PREFER_MASTER 0x400 | |
| #define GBCR_MANUAL_AS_MASTER 0x800 | |
| #define GBCR_MANUAL_CONFIG_ENABLE 0x1000 | |
| /* 1000Base-T status register fields */ | |
| #define GBSR_LP_1000HALF 0x400 | |
| #define GBSR_LP_1000FULL 0x800 | |
| #define GBSR_REMOTE_OK 0x1000 | |
| #define GBSR_LOCAL_OK 0x2000 | |
| #define GBSR_LOCAL_MASTER 0x4000 | |
| #define GBSR_MASTER_FAULT 0x8000 | |
| /* Marvell PHY interrupt status bits. */ | |
| #define MV88E1XXX_INTR_JABBER 0x0001 | |
| #define MV88E1XXX_INTR_POLARITY_CHNG 0x0002 | |
| #define MV88E1XXX_INTR_ENG_DETECT_CHNG 0x0010 | |
| #define MV88E1XXX_INTR_DOWNSHIFT 0x0020 | |
| #define MV88E1XXX_INTR_MDI_XOVER_CHNG 0x0040 | |
| #define MV88E1XXX_INTR_FIFO_OVER_UNDER 0x0080 | |
| #define MV88E1XXX_INTR_FALSE_CARRIER 0x0100 | |
| #define MV88E1XXX_INTR_SYMBOL_ERROR 0x0200 | |
| #define MV88E1XXX_INTR_LINK_CHNG 0x0400 | |
| #define MV88E1XXX_INTR_AUTONEG_DONE 0x0800 | |
| #define MV88E1XXX_INTR_PAGE_RECV 0x1000 | |
| #define MV88E1XXX_INTR_DUPLEX_CHNG 0x2000 | |
| #define MV88E1XXX_INTR_SPEED_CHNG 0x4000 | |
| #define MV88E1XXX_INTR_AUTONEG_ERR 0x8000 | |
| /* Marvell PHY specific registers. */ | |
| #define MV88E1XXX_SPECIFIC_CNTRL_REGISTER 16 | |
| #define MV88E1XXX_SPECIFIC_STATUS_REGISTER 17 | |
| #define MV88E1XXX_INTERRUPT_ENABLE_REGISTER 18 | |
| #define MV88E1XXX_INTERRUPT_STATUS_REGISTER 19 | |
| #define MV88E1XXX_EXT_PHY_SPECIFIC_CNTRL_REGISTER 20 | |
| #define MV88E1XXX_RECV_ERR_CNTR_REGISTER 21 | |
| #define MV88E1XXX_RES_REGISTER 22 | |
| #define MV88E1XXX_GLOBAL_STATUS_REGISTER 23 | |
| #define MV88E1XXX_LED_CONTROL_REGISTER 24 | |
| #define MV88E1XXX_MANUAL_LED_OVERRIDE_REGISTER 25 | |
| #define MV88E1XXX_EXT_PHY_SPECIFIC_CNTRL_2_REGISTER 26 | |
| #define MV88E1XXX_EXT_PHY_SPECIFIC_STATUS_REGISTER 27 | |
| #define MV88E1XXX_VIRTUAL_CABLE_TESTER_REGISTER 28 | |
| #define MV88E1XXX_EXTENDED_ADDR_REGISTER 29 | |
| #define MV88E1XXX_EXTENDED_REGISTER 30 | |
| /* PHY specific control register fields */ | |
| #define S_PSCR_MDI_XOVER_MODE 5 | |
| #define M_PSCR_MDI_XOVER_MODE 0x3 | |
| #define V_PSCR_MDI_XOVER_MODE(x) ((x) << S_PSCR_MDI_XOVER_MODE) | |
| #define G_PSCR_MDI_XOVER_MODE(x) (((x) >> S_PSCR_MDI_XOVER_MODE) & M_PSCR_MDI_XOVER_MODE) | |
| /* Extended PHY specific control register fields */ | |
| #define S_DOWNSHIFT_ENABLE 8 | |
| #define V_DOWNSHIFT_ENABLE (1 << S_DOWNSHIFT_ENABLE) | |
| #define S_DOWNSHIFT_CNT 9 | |
| #define M_DOWNSHIFT_CNT 0x7 | |
| #define V_DOWNSHIFT_CNT(x) ((x) << S_DOWNSHIFT_CNT) | |
| #define G_DOWNSHIFT_CNT(x) (((x) >> S_DOWNSHIFT_CNT) & M_DOWNSHIFT_CNT) | |
| /* PHY specific status register fields */ | |
| #define S_PSSR_JABBER 0 | |
| #define V_PSSR_JABBER (1 << S_PSSR_JABBER) | |
| #define S_PSSR_POLARITY 1 | |
| #define V_PSSR_POLARITY (1 << S_PSSR_POLARITY) | |
| #define S_PSSR_RX_PAUSE 2 | |
| #define V_PSSR_RX_PAUSE (1 << S_PSSR_RX_PAUSE) | |
| #define S_PSSR_TX_PAUSE 3 | |
| #define V_PSSR_TX_PAUSE (1 << S_PSSR_TX_PAUSE) | |
| #define S_PSSR_ENERGY_DETECT 4 | |
| #define V_PSSR_ENERGY_DETECT (1 << S_PSSR_ENERGY_DETECT) | |
| #define S_PSSR_DOWNSHIFT_STATUS 5 | |
| #define V_PSSR_DOWNSHIFT_STATUS (1 << S_PSSR_DOWNSHIFT_STATUS) | |
| #define S_PSSR_MDI 6 | |
| #define V_PSSR_MDI (1 << S_PSSR_MDI) | |
| #define S_PSSR_CABLE_LEN 7 | |
| #define M_PSSR_CABLE_LEN 0x7 | |
| #define V_PSSR_CABLE_LEN(x) ((x) << S_PSSR_CABLE_LEN) | |
| #define G_PSSR_CABLE_LEN(x) (((x) >> S_PSSR_CABLE_LEN) & M_PSSR_CABLE_LEN) | |
| #define S_PSSR_LINK 10 | |
| #define V_PSSR_LINK (1 << S_PSSR_LINK) | |
| #define S_PSSR_STATUS_RESOLVED 11 | |
| #define V_PSSR_STATUS_RESOLVED (1 << S_PSSR_STATUS_RESOLVED) | |
| #define S_PSSR_PAGE_RECEIVED 12 | |
| #define V_PSSR_PAGE_RECEIVED (1 << S_PSSR_PAGE_RECEIVED) | |
| #define S_PSSR_DUPLEX 13 | |
| #define V_PSSR_DUPLEX (1 << S_PSSR_DUPLEX) | |
| #define S_PSSR_SPEED 14 | |
| #define M_PSSR_SPEED 0x3 | |
| #define V_PSSR_SPEED(x) ((x) << S_PSSR_SPEED) | |
| #define G_PSSR_SPEED(x) (((x) >> S_PSSR_SPEED) & M_PSSR_SPEED) | |
| #endif |