| config CW1200 | |
| tristate "CW1200 WLAN support" | |
| depends on MAC80211 && CFG80211 | |
| help | |
| This is a driver for the ST-E CW1100 & CW1200 WLAN chipsets. | |
| This option just enables the driver core, see below for | |
| specific bus support. | |
| if CW1200 | |
| config CW1200_WLAN_SDIO | |
| tristate "Support SDIO platforms" | |
| depends on CW1200 && MMC | |
| help | |
| Enable support for the CW1200 connected via an SDIO bus. | |
| By default this driver only supports the Sagrad SG901-1091/1098 EVK | |
| and similar designs that utilize a hardware reset circuit. To | |
| support different CW1200 SDIO designs you will need to override | |
| the default platform data by calling cw1200_sdio_set_platform_data() | |
| in your board setup file. | |
| config CW1200_WLAN_SPI | |
| tristate "Support SPI platforms" | |
| depends on CW1200 && SPI | |
| help | |
| Enables support for the CW1200 connected via a SPI bus. You will | |
| need to add appropriate platform data glue in your board setup | |
| file. | |
| endif |