| /* | |
| * Support Infineon TLE62x0 driver chips | |
| * | |
| * Copyright (c) 2007 Simtec Electronics | |
| * Ben Dooks, <ben@simtec.co.uk> | |
| * | |
| * This program is free software; you can redistribute it and/or modify | |
| * it under the terms of the GNU General Public License version 2 as | |
| * published by the Free Software Foundation. | |
| */ | |
| #include <linux/device.h> | |
| #include <linux/kernel.h> | |
| #include <linux/module.h> | |
| #include <linux/slab.h> | |
| #include <linux/spi/spi.h> | |
| #include <linux/spi/tle62x0.h> | |
| #define CMD_READ 0x00 | |
| #define CMD_SET 0xff | |
| #define DIAG_NORMAL 0x03 | |
| #define DIAG_OVERLOAD 0x02 | |
| #define DIAG_OPEN 0x01 | |
| #define DIAG_SHORTGND 0x00 | |
| struct tle62x0_state { | |
| struct spi_device *us; | |
| struct mutex lock; | |
| unsigned int nr_gpio; | |
| unsigned int gpio_state; | |
| unsigned char tx_buff[4]; | |
| unsigned char rx_buff[4]; | |
| }; | |
| static int to_gpio_num(struct device_attribute *attr); | |
| static inline int tle62x0_write(struct tle62x0_state *st) | |
| { | |
| unsigned char *buff = st->tx_buff; | |
| unsigned int gpio_state = st->gpio_state; | |
| buff[0] = CMD_SET; | |
| if (st->nr_gpio == 16) { | |
| buff[1] = gpio_state >> 8; | |
| buff[2] = gpio_state; | |
| } else { | |
| buff[1] = gpio_state; | |
| } | |
| dev_dbg(&st->us->dev, "buff %3ph\n", buff); | |
| return spi_write(st->us, buff, (st->nr_gpio == 16) ? 3 : 2); | |
| } | |
| static inline int tle62x0_read(struct tle62x0_state *st) | |
| { | |
| unsigned char *txbuff = st->tx_buff; | |
| struct spi_transfer xfer = { | |
| .tx_buf = txbuff, | |
| .rx_buf = st->rx_buff, | |
| .len = (st->nr_gpio * 2) / 8, | |
| }; | |
| struct spi_message msg; | |
| txbuff[0] = CMD_READ; | |
| txbuff[1] = 0x00; | |
| txbuff[2] = 0x00; | |
| txbuff[3] = 0x00; | |
| spi_message_init(&msg); | |
| spi_message_add_tail(&xfer, &msg); | |
| return spi_sync(st->us, &msg); | |
| } | |
| static unsigned char *decode_fault(unsigned int fault_code) | |
| { | |
| fault_code &= 3; | |
| switch (fault_code) { | |
| case DIAG_NORMAL: | |
| return "N"; | |
| case DIAG_OVERLOAD: | |
| return "V"; | |
| case DIAG_OPEN: | |
| return "O"; | |
| case DIAG_SHORTGND: | |
| return "G"; | |
| } | |
| return "?"; | |
| } | |
| static ssize_t tle62x0_status_show(struct device *dev, | |
| struct device_attribute *attr, char *buf) | |
| { | |
| struct tle62x0_state *st = dev_get_drvdata(dev); | |
| char *bp = buf; | |
| unsigned char *buff = st->rx_buff; | |
| unsigned long fault = 0; | |
| int ptr; | |
| int ret; | |
| mutex_lock(&st->lock); | |
| ret = tle62x0_read(st); | |
| dev_dbg(dev, "tle62x0_read() returned %d\n", ret); | |
| if (ret < 0) { | |
| mutex_unlock(&st->lock); | |
| return ret; | |
| } | |
| for (ptr = 0; ptr < (st->nr_gpio * 2)/8; ptr += 1) { | |
| fault <<= 8; | |
| fault |= ((unsigned long)buff[ptr]); | |
| dev_dbg(dev, "byte %d is %02x\n", ptr, buff[ptr]); | |
| } | |
| for (ptr = 0; ptr < st->nr_gpio; ptr++) { | |
| bp += sprintf(bp, "%s ", decode_fault(fault >> (ptr * 2))); | |
| } | |
| *bp++ = '\n'; | |
| mutex_unlock(&st->lock); | |
| return bp - buf; | |
| } | |
| static DEVICE_ATTR(status_show, S_IRUGO, tle62x0_status_show, NULL); | |
| static ssize_t tle62x0_gpio_show(struct device *dev, | |
| struct device_attribute *attr, char *buf) | |
| { | |
| struct tle62x0_state *st = dev_get_drvdata(dev); | |
| int gpio_num = to_gpio_num(attr); | |
| int value; | |
| mutex_lock(&st->lock); | |
| value = (st->gpio_state >> gpio_num) & 1; | |
| mutex_unlock(&st->lock); | |
| return snprintf(buf, PAGE_SIZE, "%d", value); | |
| } | |
| static ssize_t tle62x0_gpio_store(struct device *dev, | |
| struct device_attribute *attr, | |
| const char *buf, size_t len) | |
| { | |
| struct tle62x0_state *st = dev_get_drvdata(dev); | |
| int gpio_num = to_gpio_num(attr); | |
| unsigned long val; | |
| char *endp; | |
| val = simple_strtoul(buf, &endp, 0); | |
| if (buf == endp) | |
| return -EINVAL; | |
| dev_dbg(dev, "setting gpio %d to %ld\n", gpio_num, val); | |
| mutex_lock(&st->lock); | |
| if (val) | |
| st->gpio_state |= 1 << gpio_num; | |
| else | |
| st->gpio_state &= ~(1 << gpio_num); | |
| tle62x0_write(st); | |
| mutex_unlock(&st->lock); | |
| return len; | |
| } | |
| static DEVICE_ATTR(gpio1, S_IWUSR|S_IRUGO, | |
| tle62x0_gpio_show, tle62x0_gpio_store); | |
| static DEVICE_ATTR(gpio2, S_IWUSR|S_IRUGO, | |
| tle62x0_gpio_show, tle62x0_gpio_store); | |
| static DEVICE_ATTR(gpio3, S_IWUSR|S_IRUGO, | |
| tle62x0_gpio_show, tle62x0_gpio_store); | |
| static DEVICE_ATTR(gpio4, S_IWUSR|S_IRUGO, | |
| tle62x0_gpio_show, tle62x0_gpio_store); | |
| static DEVICE_ATTR(gpio5, S_IWUSR|S_IRUGO, | |
| tle62x0_gpio_show, tle62x0_gpio_store); | |
| static DEVICE_ATTR(gpio6, S_IWUSR|S_IRUGO, | |
| tle62x0_gpio_show, tle62x0_gpio_store); | |
| static DEVICE_ATTR(gpio7, S_IWUSR|S_IRUGO, | |
| tle62x0_gpio_show, tle62x0_gpio_store); | |
| static DEVICE_ATTR(gpio8, S_IWUSR|S_IRUGO, | |
| tle62x0_gpio_show, tle62x0_gpio_store); | |
| static DEVICE_ATTR(gpio9, S_IWUSR|S_IRUGO, | |
| tle62x0_gpio_show, tle62x0_gpio_store); | |
| static DEVICE_ATTR(gpio10, S_IWUSR|S_IRUGO, | |
| tle62x0_gpio_show, tle62x0_gpio_store); | |
| static DEVICE_ATTR(gpio11, S_IWUSR|S_IRUGO, | |
| tle62x0_gpio_show, tle62x0_gpio_store); | |
| static DEVICE_ATTR(gpio12, S_IWUSR|S_IRUGO, | |
| tle62x0_gpio_show, tle62x0_gpio_store); | |
| static DEVICE_ATTR(gpio13, S_IWUSR|S_IRUGO, | |
| tle62x0_gpio_show, tle62x0_gpio_store); | |
| static DEVICE_ATTR(gpio14, S_IWUSR|S_IRUGO, | |
| tle62x0_gpio_show, tle62x0_gpio_store); | |
| static DEVICE_ATTR(gpio15, S_IWUSR|S_IRUGO, | |
| tle62x0_gpio_show, tle62x0_gpio_store); | |
| static DEVICE_ATTR(gpio16, S_IWUSR|S_IRUGO, | |
| tle62x0_gpio_show, tle62x0_gpio_store); | |
| static struct device_attribute *gpio_attrs[] = { | |
| [0] = &dev_attr_gpio1, | |
| [1] = &dev_attr_gpio2, | |
| [2] = &dev_attr_gpio3, | |
| [3] = &dev_attr_gpio4, | |
| [4] = &dev_attr_gpio5, | |
| [5] = &dev_attr_gpio6, | |
| [6] = &dev_attr_gpio7, | |
| [7] = &dev_attr_gpio8, | |
| [8] = &dev_attr_gpio9, | |
| [9] = &dev_attr_gpio10, | |
| [10] = &dev_attr_gpio11, | |
| [11] = &dev_attr_gpio12, | |
| [12] = &dev_attr_gpio13, | |
| [13] = &dev_attr_gpio14, | |
| [14] = &dev_attr_gpio15, | |
| [15] = &dev_attr_gpio16 | |
| }; | |
| static int to_gpio_num(struct device_attribute *attr) | |
| { | |
| int ptr; | |
| for (ptr = 0; ptr < ARRAY_SIZE(gpio_attrs); ptr++) { | |
| if (gpio_attrs[ptr] == attr) | |
| return ptr; | |
| } | |
| return -1; | |
| } | |
| static int tle62x0_probe(struct spi_device *spi) | |
| { | |
| struct tle62x0_state *st; | |
| struct tle62x0_pdata *pdata; | |
| int ptr; | |
| int ret; | |
| pdata = dev_get_platdata(&spi->dev); | |
| if (pdata == NULL) { | |
| dev_err(&spi->dev, "no device data specified\n"); | |
| return -EINVAL; | |
| } | |
| st = kzalloc(sizeof(struct tle62x0_state), GFP_KERNEL); | |
| if (st == NULL) | |
| return -ENOMEM; | |
| st->us = spi; | |
| st->nr_gpio = pdata->gpio_count; | |
| st->gpio_state = pdata->init_state; | |
| mutex_init(&st->lock); | |
| ret = device_create_file(&spi->dev, &dev_attr_status_show); | |
| if (ret) { | |
| dev_err(&spi->dev, "cannot create status attribute\n"); | |
| goto err_status; | |
| } | |
| for (ptr = 0; ptr < pdata->gpio_count; ptr++) { | |
| ret = device_create_file(&spi->dev, gpio_attrs[ptr]); | |
| if (ret) { | |
| dev_err(&spi->dev, "cannot create gpio attribute\n"); | |
| goto err_gpios; | |
| } | |
| } | |
| /* tle62x0_write(st); */ | |
| spi_set_drvdata(spi, st); | |
| return 0; | |
| err_gpios: | |
| while (--ptr >= 0) | |
| device_remove_file(&spi->dev, gpio_attrs[ptr]); | |
| device_remove_file(&spi->dev, &dev_attr_status_show); | |
| err_status: | |
| kfree(st); | |
| return ret; | |
| } | |
| static int tle62x0_remove(struct spi_device *spi) | |
| { | |
| struct tle62x0_state *st = spi_get_drvdata(spi); | |
| int ptr; | |
| for (ptr = 0; ptr < st->nr_gpio; ptr++) | |
| device_remove_file(&spi->dev, gpio_attrs[ptr]); | |
| device_remove_file(&spi->dev, &dev_attr_status_show); | |
| kfree(st); | |
| return 0; | |
| } | |
| static struct spi_driver tle62x0_driver = { | |
| .driver = { | |
| .name = "tle62x0", | |
| }, | |
| .probe = tle62x0_probe, | |
| .remove = tle62x0_remove, | |
| }; | |
| module_spi_driver(tle62x0_driver); | |
| MODULE_AUTHOR("Ben Dooks <ben@simtec.co.uk>"); | |
| MODULE_DESCRIPTION("TLE62x0 SPI driver"); | |
| MODULE_LICENSE("GPL v2"); | |
| MODULE_ALIAS("spi:tle62x0"); |