| /* Copyright (c) 2010, Code Aurora Forum. All rights reserved. | |
| * | |
| * This program is free software; you can redistribute it and/or modify | |
| * it under the terms of the GNU General Public License version 2 and | |
| * only version 2 as published by the Free Software Foundation. | |
| */ | |
| #include <linux/module.h> | |
| #include <linux/platform_device.h> | |
| #include <linux/pm_runtime.h> | |
| #include <linux/usb/msm_hsusb_hw.h> | |
| #include <linux/usb/ulpi.h> | |
| #include <linux/usb/gadget.h> | |
| #include <linux/usb/chipidea.h> | |
| #include "ci.h" | |
| #define MSM_USB_BASE (ci->hw_bank.abs) | |
| static void ci_hdrc_msm_notify_event(struct ci_hdrc *ci, unsigned event) | |
| { | |
| struct device *dev = ci->gadget.dev.parent; | |
| switch (event) { | |
| case CI_HDRC_CONTROLLER_RESET_EVENT: | |
| dev_dbg(dev, "CI_HDRC_CONTROLLER_RESET_EVENT received\n"); | |
| writel(0, USB_AHBBURST); | |
| /* use AHB transactor, allow posted data writes */ | |
| writel(0x8, USB_AHBMODE); | |
| usb_phy_init(ci->usb_phy); | |
| break; | |
| case CI_HDRC_CONTROLLER_STOPPED_EVENT: | |
| dev_dbg(dev, "CI_HDRC_CONTROLLER_STOPPED_EVENT received\n"); | |
| /* | |
| * Put the phy in non-driving mode. Otherwise host | |
| * may not detect soft-disconnection. | |
| */ | |
| usb_phy_notify_disconnect(ci->usb_phy, USB_SPEED_UNKNOWN); | |
| break; | |
| default: | |
| dev_dbg(dev, "unknown ci_hdrc event\n"); | |
| break; | |
| } | |
| } | |
| static struct ci_hdrc_platform_data ci_hdrc_msm_platdata = { | |
| .name = "ci_hdrc_msm", | |
| .capoffset = DEF_CAPOFFSET, | |
| .flags = CI_HDRC_REGS_SHARED | | |
| CI_HDRC_DISABLE_STREAMING, | |
| .notify_event = ci_hdrc_msm_notify_event, | |
| }; | |
| static int ci_hdrc_msm_probe(struct platform_device *pdev) | |
| { | |
| struct platform_device *plat_ci; | |
| struct usb_phy *phy; | |
| dev_dbg(&pdev->dev, "ci_hdrc_msm_probe\n"); | |
| /* | |
| * OTG(PHY) driver takes care of PHY initialization, clock management, | |
| * powering up VBUS, mapping of registers address space and power | |
| * management. | |
| */ | |
| phy = devm_usb_get_phy_by_phandle(&pdev->dev, "usb-phy", 0); | |
| if (IS_ERR(phy)) | |
| return PTR_ERR(phy); | |
| ci_hdrc_msm_platdata.usb_phy = phy; | |
| plat_ci = ci_hdrc_add_device(&pdev->dev, | |
| pdev->resource, pdev->num_resources, | |
| &ci_hdrc_msm_platdata); | |
| if (IS_ERR(plat_ci)) { | |
| dev_err(&pdev->dev, "ci_hdrc_add_device failed!\n"); | |
| return PTR_ERR(plat_ci); | |
| } | |
| platform_set_drvdata(pdev, plat_ci); | |
| pm_runtime_no_callbacks(&pdev->dev); | |
| pm_runtime_enable(&pdev->dev); | |
| return 0; | |
| } | |
| static int ci_hdrc_msm_remove(struct platform_device *pdev) | |
| { | |
| struct platform_device *plat_ci = platform_get_drvdata(pdev); | |
| pm_runtime_disable(&pdev->dev); | |
| ci_hdrc_remove_device(plat_ci); | |
| return 0; | |
| } | |
| static const struct of_device_id msm_ci_dt_match[] = { | |
| { .compatible = "qcom,ci-hdrc", }, | |
| { } | |
| }; | |
| MODULE_DEVICE_TABLE(of, msm_ci_dt_match); | |
| static struct platform_driver ci_hdrc_msm_driver = { | |
| .probe = ci_hdrc_msm_probe, | |
| .remove = ci_hdrc_msm_remove, | |
| .driver = { | |
| .name = "msm_hsusb", | |
| .of_match_table = msm_ci_dt_match, | |
| }, | |
| }; | |
| module_platform_driver(ci_hdrc_msm_driver); | |
| MODULE_ALIAS("platform:msm_hsusb"); | |
| MODULE_ALIAS("platform:ci13xxx_msm"); | |
| MODULE_LICENSE("GPL v2"); |