| config SND_OMAP_SOC | |
| tristate "SoC Audio for the Texas Instruments OMAP chips" | |
| depends on (ARCH_OMAP && DMA_OMAP) || (ARM && COMPILE_TEST) | |
| select SND_DMAENGINE_PCM | |
| config SND_OMAP_SOC_DMIC | |
| tristate | |
| config SND_OMAP_SOC_MCBSP | |
| tristate | |
| config SND_OMAP_SOC_MCPDM | |
| tristate | |
| config SND_OMAP_SOC_HDMI_AUDIO | |
| tristate "HDMI audio support for OMAP4+ based SoCs" | |
| depends on SND_OMAP_SOC | |
| help | |
| For HDMI audio to work OMAPDSS HDMI support should be | |
| enabled. | |
| The hdmi audio driver implements cpu-dai component using the | |
| callbacks provided by OMAPDSS and registers the component | |
| under DSS HDMI device. Omap-pcm is registered for platform | |
| component also under DSS HDMI device. Dummy codec is used as | |
| as codec component. The hdmi audio driver implements also | |
| the card and registers it under its own platform device. | |
| The device for the driver is registered by OMAPDSS hdmi | |
| driver. | |
| config SND_OMAP_SOC_N810 | |
| tristate "SoC Audio support for Nokia N810" | |
| depends on SND_OMAP_SOC && MACH_NOKIA_N810 && I2C | |
| depends on OMAP_MUX | |
| select SND_OMAP_SOC_MCBSP | |
| select SND_SOC_TLV320AIC3X | |
| help | |
| Say Y if you want to add support for SoC audio on Nokia N810. | |
| config SND_OMAP_SOC_RX51 | |
| tristate "SoC Audio support for Nokia N900 (RX-51)" | |
| depends on SND_OMAP_SOC && ARM && I2C | |
| select SND_OMAP_SOC_MCBSP | |
| select SND_SOC_TLV320AIC3X | |
| select SND_SOC_TPA6130A2 | |
| depends on GPIOLIB | |
| help | |
| Say Y if you want to add support for SoC audio on Nokia N900 | |
| cellphone. | |
| config SND_OMAP_SOC_AMS_DELTA | |
| tristate "SoC Audio support for Amstrad E3 (Delta) videophone" | |
| depends on SND_OMAP_SOC && MACH_AMS_DELTA && TTY | |
| select SND_OMAP_SOC_MCBSP | |
| select SND_SOC_CX20442 | |
| help | |
| Say Y if you want to add support for SoC audio device connected to | |
| a handset and a speakerphone found on Amstrad E3 (Delta) videophone. | |
| Note that in order to get those devices fully supported, you have to | |
| build the kernel with standard serial port driver included and | |
| configured for at least 4 ports. Then, from userspace, you must load | |
| a line discipline #19 on the modem (ttyS3) serial line. The simplest | |
| way to achieve this is to install util-linux-ng and use the included | |
| ldattach utility. This can be started automatically from udev, | |
| a simple rule like this one should do the trick (it does for me): | |
| ACTION=="add", KERNEL=="controlC0", \ | |
| RUN+="/usr/sbin/ldattach 19 /dev/ttyS3" | |
| config SND_OMAP_SOC_OSK5912 | |
| tristate "SoC Audio support for omap osk5912" | |
| depends on SND_OMAP_SOC && MACH_OMAP_OSK && I2C | |
| select SND_OMAP_SOC_MCBSP | |
| select SND_SOC_TLV320AIC23_I2C | |
| help | |
| Say Y if you want to add support for SoC audio on osk5912. | |
| config SND_OMAP_SOC_AM3517EVM | |
| tristate "SoC Audio support for OMAP3517 / AM3517 EVM" | |
| depends on SND_OMAP_SOC && MACH_OMAP3517EVM && I2C | |
| select SND_OMAP_SOC_MCBSP | |
| select SND_SOC_TLV320AIC23_I2C | |
| help | |
| Say Y if you want to add support for SoC audio on the OMAP3517 / AM3517 | |
| EVM. | |
| config SND_OMAP_SOC_OMAP_TWL4030 | |
| tristate "SoC Audio support for TI SoC based boards with twl4030 codec" | |
| depends on TWL4030_CORE && SND_OMAP_SOC | |
| select SND_OMAP_SOC_MCBSP | |
| select SND_SOC_TWL4030 | |
| help | |
| Say Y if you want to add support for SoC audio on TI SoC based boards | |
| using twl4030 as c codec. This driver currently supports: | |
| - Beagleboard or Devkit8000 | |
| - Gumstix Overo or CompuLab CM-T35/CM-T3730 | |
| - IGEP v2 | |
| - OMAP3EVM | |
| - SDP3430 | |
| - Zoom2 | |
| config SND_OMAP_SOC_OMAP_ABE_TWL6040 | |
| tristate "SoC Audio support for OMAP boards using ABE and twl6040 codec" | |
| depends on TWL6040_CORE && SND_OMAP_SOC && COMMON_CLK | |
| depends on ARCH_OMAP4 || (SOC_OMAP5 && MFD_PALMAS) || COMPILE_TEST | |
| select SND_OMAP_SOC_DMIC | |
| select SND_OMAP_SOC_MCPDM | |
| select SND_SOC_TWL6040 | |
| select SND_SOC_DMIC | |
| select COMMON_CLK_PALMAS if (SOC_OMAP5 && MFD_PALMAS) | |
| select CLK_TWL6040 | |
| help | |
| Say Y if you want to add support for SoC audio on OMAP boards using | |
| ABE and twl6040 codec. This driver currently supports: | |
| - SDP4430/Blaze boards | |
| - PandaBoard (4430) | |
| - PandaBoardES (4460) | |
| - omap5-uevm (5432) | |
| config SND_OMAP_SOC_OMAP3_PANDORA | |
| tristate "SoC Audio support for OMAP3 Pandora" | |
| depends on TWL4030_CORE && SND_OMAP_SOC && MACH_OMAP3_PANDORA | |
| select SND_OMAP_SOC_MCBSP | |
| select SND_SOC_TWL4030 | |
| help | |
| Say Y if you want to add support for SoC audio on the OMAP3 Pandora. |