| /* |
| * arch/sh/boards/landisk/io.c |
| * |
| * Copyright (C) 2001 Ian da Silva, Jeremy Siegel |
| * Based largely on io_se.c. |
| * |
| * I/O routine for I-O Data Device, Inc. LANDISK. |
| * |
| * Initial version only to support LAN access; some |
| * placeholder code from io_landisk.c left in with the |
| * expectation of later SuperIO and PCMCIA access. |
| */ |
| /* |
| * modifed by kogiidena |
| * 2005.03.03 |
| */ |
| |
| #include <linux/kernel.h> |
| #include <linux/types.h> |
| #include <asm/io.h> |
| #include <asm/landisk/iodata_landisk.h> |
| #include <asm/addrspace.h> |
| |
| #include <linux/module.h> |
| #include <linux/pci.h> |
| #include "../../drivers/pci/pci-sh7751.h" |
| |
| extern void *area5_io_base; /* Area 5 I/O Base address */ |
| extern void *area6_io_base; /* Area 6 I/O Base address */ |
| |
| /* |
| * The 7751R LANDISK uses the built-in PCI controller (PCIC) |
| * of the 7751R processor, and has a SuperIO accessible via the PCI. |
| * The board also includes a PCMCIA controller on its memory bus, |
| * like the other Solution Engine boards. |
| */ |
| |
| #define PCIIOBR (volatile long *)PCI_REG(SH7751_PCIIOBR) |
| #define PCIMBR (volatile long *)PCI_REG(SH7751_PCIMBR) |
| #define PCI_IO_AREA SH7751_PCI_IO_BASE |
| #define PCI_MEM_AREA SH7751_PCI_CONFIG_BASE |
| |
| #define PCI_IOMAP(adr) (PCI_IO_AREA + (adr & ~SH7751_PCIIOBR_MASK)) |
| |
| #define maybebadio(name,port) \ |
| printk("bad PC-like io %s for port 0x%lx at 0x%08x\n", \ |
| #name, (port), (__u32) __builtin_return_address(0)) |
| |
| static inline void delay(void) |
| { |
| ctrl_inw(0xa0000000); |
| } |
| |
| static inline unsigned long port2adr(unsigned int port) |
| { |
| if ((0x1f0 <= port && port < 0x1f8) || port == 0x3f6) |
| if (port == 0x3f6) |
| return ((unsigned long)area5_io_base + 0x2c); |
| else |
| return ((unsigned long)area5_io_base + PA_PIDE_OFFSET + |
| ((port - 0x1f0) << 1)); |
| else if ((0x170 <= port && port < 0x178) || port == 0x376) |
| if (port == 0x376) |
| return ((unsigned long)area6_io_base + 0x2c); |
| else |
| return ((unsigned long)area6_io_base + PA_SIDE_OFFSET + |
| ((port - 0x170) << 1)); |
| else |
| maybebadio(port2adr, (unsigned long)port); |
| |
| return port; |
| } |
| |
| /* In case someone configures the kernel w/o PCI support: in that */ |
| /* scenario, don't ever bother to check for PCI-window addresses */ |
| |
| /* NOTE: WINDOW CHECK MAY BE A BIT OFF, HIGH PCIBIOS_MIN_IO WRAPS? */ |
| #if defined(CONFIG_PCI) |
| #define CHECK_SH7751_PCIIO(port) \ |
| ((port >= PCIBIOS_MIN_IO) && (port < (PCIBIOS_MIN_IO + SH7751_PCI_IO_SIZE))) |
| #else |
| #define CHECK_SH_7751_PCIIO(port) (0) |
| #endif |
| |
| /* |
| * General outline: remap really low stuff [eventually] to SuperIO, |
| * stuff in PCI IO space (at or above window at pci.h:PCIBIOS_MIN_IO) |
| * is mapped through the PCI IO window. Stuff with high bits (PXSEG) |
| * should be way beyond the window, and is used w/o translation for |
| * compatibility. |
| */ |
| unsigned char landisk_inb(unsigned long port) |
| { |
| if (PXSEG(port)) |
| return *(volatile unsigned char *)port; |
| else if (CHECK_SH7751_PCIIO(port)) |
| return *(volatile unsigned char *)PCI_IOMAP(port); |
| else |
| return (*(volatile unsigned short *)port2adr(port) & 0xff); |
| } |
| |
| unsigned char landisk_inb_p(unsigned long port) |
| { |
| unsigned char v; |
| |
| if (PXSEG(port)) |
| v = *(volatile unsigned char *)port; |
| else if (CHECK_SH7751_PCIIO(port)) |
| v = *(volatile unsigned char *)PCI_IOMAP(port); |
| else |
| v = (*(volatile unsigned short *)port2adr(port) & 0xff); |
| delay(); |
| |
| return v; |
| } |
| |
| unsigned short landisk_inw(unsigned long port) |
| { |
| if (PXSEG(port)) |
| return *(volatile unsigned short *)port; |
| else if (CHECK_SH7751_PCIIO(port)) |
| return *(volatile unsigned short *)PCI_IOMAP(port); |
| else |
| maybebadio(inw, port); |
| |
| return 0; |
| } |
| |
| unsigned int landisk_inl(unsigned long port) |
| { |
| if (PXSEG(port)) |
| return *(volatile unsigned long *)port; |
| else if (CHECK_SH7751_PCIIO(port)) |
| return *(volatile unsigned long *)PCI_IOMAP(port); |
| else |
| maybebadio(inl, port); |
| |
| return 0; |
| } |
| |
| void landisk_outb(unsigned char value, unsigned long port) |
| { |
| |
| if (PXSEG(port)) |
| *(volatile unsigned char *)port = value; |
| else if (CHECK_SH7751_PCIIO(port)) |
| *(volatile unsigned char *)PCI_IOMAP(port) = value; |
| else |
| *(volatile unsigned short *)port2adr(port) = value; |
| } |
| |
| void landisk_outb_p(unsigned char value, unsigned long port) |
| { |
| if (PXSEG(port)) |
| *(volatile unsigned char *)port = value; |
| else if (CHECK_SH7751_PCIIO(port)) |
| *(volatile unsigned char *)PCI_IOMAP(port) = value; |
| else |
| *(volatile unsigned short *)port2adr(port) = value; |
| delay(); |
| } |
| |
| void landisk_outw(unsigned short value, unsigned long port) |
| { |
| if (PXSEG(port)) |
| *(volatile unsigned short *)port = value; |
| else if (CHECK_SH7751_PCIIO(port)) |
| *(volatile unsigned short *)PCI_IOMAP(port) = value; |
| else |
| maybebadio(outw, port); |
| } |
| |
| void landisk_outl(unsigned int value, unsigned long port) |
| { |
| if (PXSEG(port)) |
| *(volatile unsigned long *)port = value; |
| else if (CHECK_SH7751_PCIIO(port)) |
| *(volatile unsigned long *)PCI_IOMAP(port) = value; |
| else |
| maybebadio(outl, port); |
| } |
| |
| void landisk_insb(unsigned long port, void *addr, unsigned long count) |
| { |
| if (PXSEG(port)) |
| while (count--) |
| *((unsigned char *)addr)++ = |
| *(volatile unsigned char *)port; |
| else if (CHECK_SH7751_PCIIO(port)) { |
| volatile __u8 *bp = (__u8 *) PCI_IOMAP(port); |
| |
| while (count--) |
| *((volatile unsigned char *)addr)++ = *bp; |
| } else { |
| volatile __u16 *p = (volatile unsigned short *)port2adr(port); |
| |
| while (count--) |
| *((unsigned char *)addr)++ = *p; |
| } |
| } |
| |
| void landisk_insw(unsigned long port, void *addr, unsigned long count) |
| { |
| volatile __u16 *p; |
| |
| if (PXSEG(port)) |
| p = (volatile unsigned short *)port; |
| else if (CHECK_SH7751_PCIIO(port)) |
| p = (volatile unsigned short *)PCI_IOMAP(port); |
| else |
| p = (volatile unsigned short *)port2adr(port); |
| while (count--) |
| *((__u16 *) addr)++ = *p; |
| } |
| |
| void landisk_insl(unsigned long port, void *addr, unsigned long count) |
| { |
| if (CHECK_SH7751_PCIIO(port)) { |
| volatile __u32 *p = (__u32 *) PCI_IOMAP(port); |
| |
| while (count--) |
| *((__u32 *) addr)++ = *p; |
| } else |
| maybebadio(insl, port); |
| } |
| |
| void landisk_outsb(unsigned long port, const void *addr, unsigned long count) |
| { |
| if (PXSEG(port)) |
| while (count--) |
| *(volatile unsigned char *)port = |
| *((unsigned char *)addr)++; |
| else if (CHECK_SH7751_PCIIO(port)) { |
| volatile __u8 *bp = (__u8 *) PCI_IOMAP(port); |
| |
| while (count--) |
| *bp = *((volatile unsigned char *)addr)++; |
| } else { |
| volatile __u16 *p = (volatile unsigned short *)port2adr(port); |
| |
| while (count--) |
| *p = *((unsigned char *)addr)++; |
| } |
| } |
| |
| void landisk_outsw(unsigned long port, const void *addr, unsigned long count) |
| { |
| volatile __u16 *p; |
| |
| if (PXSEG(port)) |
| p = (volatile unsigned short *)port; |
| else if (CHECK_SH7751_PCIIO(port)) |
| p = (volatile unsigned short *)PCI_IOMAP(port); |
| else |
| p = (volatile unsigned short *)port2adr(port); |
| while (count--) |
| *p = *((__u16 *) addr)++; |
| } |
| |
| void landisk_outsl(unsigned long port, const void *addr, unsigned long count) |
| { |
| if (CHECK_SH7751_PCIIO(port)) { |
| volatile __u32 *p = (__u32 *) PCI_IOMAP(port); |
| |
| while (count--) |
| *p = *((__u32 *) addr)++; |
| } else |
| maybebadio(outsl, port); |
| } |
| |
| /* For read/write calls, just copy generic (pass-thru); PCIMBR is */ |
| /* already set up. For a larger memory space, these would need to */ |
| /* reset PCIMBR as needed on a per-call basis... */ |
| |
| unsigned char landisk_readb(unsigned long addr) |
| { |
| return *(volatile unsigned char *)addr; |
| } |
| |
| unsigned short landisk_readw(unsigned long addr) |
| { |
| return *(volatile unsigned short *)addr; |
| } |
| |
| unsigned int landisk_readl(unsigned long addr) |
| { |
| return *(volatile unsigned long *)addr; |
| } |
| |
| void landisk_writeb(unsigned char b, unsigned long addr) |
| { |
| *(volatile unsigned char *)addr = b; |
| } |
| |
| void landisk_writew(unsigned short b, unsigned long addr) |
| { |
| *(volatile unsigned short *)addr = b; |
| } |
| |
| void landisk_writel(unsigned int b, unsigned long addr) |
| { |
| *(volatile unsigned long *)addr = b; |
| } |
| |
| void *landisk_ioremap(unsigned long offset, unsigned long size) |
| { |
| if (offset >= 0xfd000000) |
| return (void *)offset; |
| else |
| return (void *)P2SEGADDR(offset); |
| } |
| |
| void landisk_iounmap(void *addr) |
| { |
| } |
| |
| /* Map ISA bus address to the real address. Only for PCMCIA. */ |
| |
| unsigned long landisk_isa_port2addr(unsigned long offset) |
| { |
| return port2adr(offset); |
| } |