blob: 83da4931d832688f51e19a56aaa03af8482e721a [file] [log] [blame]
* Rockchip SPI Controller
The Rockchip SPI controller is used to interface with various devices such as flash
and display controllers using the SPI communication interface.
Required Properties:
- compatible: should be one of the following.
"rockchip,rk3036-spi" for rk3036 SoCS.
"rockchip,rk3066-spi" for rk3066 SoCs.
"rockchip,rk3188-spi" for rk3188 SoCs.
"rockchip,rk3228-spi" for rk3228 SoCS.
"rockchip,rk3288-spi" for rk3288 SoCs.
"rockchip,rk3368-spi" for rk3368 SoCs.
"rockchip,rk3399-spi" for rk3399 SoCs.
- reg: physical base address of the controller and length of memory mapped
region.
- interrupts: The interrupt number to the cpu. The interrupt specifier format
depends on the interrupt controller.
- clocks: Must contain an entry for each entry in clock-names.
- clock-names: Shall be "spiclk" for the transfer-clock, and "apb_pclk" for
the peripheral clock.
- #address-cells: should be 1.
- #size-cells: should be 0.
Optional Properties:
- dmas: DMA specifiers for tx and rx dma. See the DMA client binding,
Documentation/devicetree/bindings/dma/dma.txt
- dma-names: DMA request names should include "tx" and "rx" if present.
- rx-sample-delay-ns: nanoseconds to delay after the SCLK edge before sampling
Rx data (may need to be fine tuned for high capacitance lines).
No delay (0) by default.
- pinctrl-names: Names for the pin configuration(s); may be "default" or
"sleep", where the "sleep" configuration may describe the state
the pins should be in during system suspend. See also
pinctrl/pinctrl-bindings.txt.
Example:
spi0: spi@ff110000 {
compatible = "rockchip,rk3066-spi";
reg = <0xff110000 0x1000>;
dmas = <&pdma1 11>, <&pdma1 12>;
dma-names = "tx", "rx";
rx-sample-delay-ns = <10>;
#address-cells = <1>;
#size-cells = <0>;
interrupts = <GIC_SPI 44 IRQ_TYPE_LEVEL_HIGH>;
clocks = <&cru SCLK_SPI0>, <&cru PCLK_SPI0>;
clock-names = "spiclk", "apb_pclk";
pinctrl-0 = <&spi1_pins>;
pinctrl-1 = <&spi1_sleep>;
pinctrl-names = "default", "sleep";
};