| Toshiba et8ek8 5MP sensor |
| |
| Toshiba et8ek8 5MP sensor is an image sensor found in Nokia N900 device |
| |
| More detailed documentation can be found in |
| Documentation/devicetree/bindings/media/video-interfaces.txt . |
| |
| |
| Mandatory properties |
| -------------------- |
| |
| - compatible: "toshiba,et8ek8" |
| - reg: I2C address (0x3e, or an alternative address) |
| - vana-supply: Analogue voltage supply (VANA), 2.8 volts |
| - clocks: External clock to the sensor |
| - clock-frequency: Frequency of the external clock to the sensor. Camera |
| driver will set this frequency on the external clock. The clock frequency is |
| a pre-determined frequency known to be suitable to the board. |
| - reset-gpios: XSHUTDOWN GPIO. The XSHUTDOWN signal is active low. The sensor |
| is in hardware standby mode when the signal is in the low state. |
| |
| |
| Endpoint node mandatory properties |
| ---------------------------------- |
| |
| - remote-endpoint: A phandle to the bus receiver's endpoint node. |
| |
| |
| Example |
| ------- |
| |
| &i2c3 { |
| clock-frequency = <400000>; |
| |
| cam1: camera@3e { |
| compatible = "toshiba,et8ek8"; |
| reg = <0x3e>; |
| vana-supply = <&vaux4>; |
| clocks = <&isp 0>; |
| clock-frequency = <9600000>; |
| reset-gpio = <&gpio4 6 GPIO_ACTIVE_HIGH>; /* 102 */ |
| port { |
| csi_cam1: endpoint { |
| remote-endpoint = <&csi_out1>; |
| }; |
| }; |
| }; |
| }; |
