| /* | |
| * Xilinx Spartan6 Slave Serial SPI Driver | |
| * | |
| * Copyright (C) 2017 DENX Software Engineering | |
| * | |
| * Anatolij Gustschin <agust@denx.de> | |
| * | |
| * This program is free software; you can redistribute it and/or modify it | |
| * under the terms and conditions of the GNU General Public License, | |
| * version 2, as published by the Free Software Foundation. | |
| * | |
| * Manage Xilinx FPGA firmware that is loaded over SPI using | |
| * the slave serial configuration interface. | |
| */ | |
| #include <linux/delay.h> | |
| #include <linux/device.h> | |
| #include <linux/fpga/fpga-mgr.h> | |
| #include <linux/gpio/consumer.h> | |
| #include <linux/module.h> | |
| #include <linux/mod_devicetable.h> | |
| #include <linux/of.h> | |
| #include <linux/spi/spi.h> | |
| #include <linux/sizes.h> | |
| struct xilinx_spi_conf { | |
| struct spi_device *spi; | |
| struct gpio_desc *prog_b; | |
| struct gpio_desc *done; | |
| }; | |
| static enum fpga_mgr_states xilinx_spi_state(struct fpga_manager *mgr) | |
| { | |
| struct xilinx_spi_conf *conf = mgr->priv; | |
| if (!gpiod_get_value(conf->done)) | |
| return FPGA_MGR_STATE_RESET; | |
| return FPGA_MGR_STATE_UNKNOWN; | |
| } | |
| static int xilinx_spi_write_init(struct fpga_manager *mgr, | |
| struct fpga_image_info *info, | |
| const char *buf, size_t count) | |
| { | |
| struct xilinx_spi_conf *conf = mgr->priv; | |
| const size_t prog_latency_7500us = 7500; | |
| const size_t prog_pulse_1us = 1; | |
| if (info->flags & FPGA_MGR_PARTIAL_RECONFIG) { | |
| dev_err(&mgr->dev, "Partial reconfiguration not supported.\n"); | |
| return -EINVAL; | |
| } | |
| gpiod_set_value(conf->prog_b, 1); | |
| udelay(prog_pulse_1us); /* min is 500 ns */ | |
| gpiod_set_value(conf->prog_b, 0); | |
| if (gpiod_get_value(conf->done)) { | |
| dev_err(&mgr->dev, "Unexpected DONE pin state...\n"); | |
| return -EIO; | |
| } | |
| /* program latency */ | |
| usleep_range(prog_latency_7500us, prog_latency_7500us + 100); | |
| return 0; | |
| } | |
| static int xilinx_spi_write(struct fpga_manager *mgr, const char *buf, | |
| size_t count) | |
| { | |
| struct xilinx_spi_conf *conf = mgr->priv; | |
| const char *fw_data = buf; | |
| const char *fw_data_end = fw_data + count; | |
| while (fw_data < fw_data_end) { | |
| size_t remaining, stride; | |
| int ret; | |
| remaining = fw_data_end - fw_data; | |
| stride = min_t(size_t, remaining, SZ_4K); | |
| ret = spi_write(conf->spi, fw_data, stride); | |
| if (ret) { | |
| dev_err(&mgr->dev, "SPI error in firmware write: %d\n", | |
| ret); | |
| return ret; | |
| } | |
| fw_data += stride; | |
| } | |
| return 0; | |
| } | |
| static int xilinx_spi_apply_cclk_cycles(struct xilinx_spi_conf *conf) | |
| { | |
| struct spi_device *spi = conf->spi; | |
| const u8 din_data[1] = { 0xff }; | |
| int ret; | |
| ret = spi_write(conf->spi, din_data, sizeof(din_data)); | |
| if (ret) | |
| dev_err(&spi->dev, "applying CCLK cycles failed: %d\n", ret); | |
| return ret; | |
| } | |
| static int xilinx_spi_write_complete(struct fpga_manager *mgr, | |
| struct fpga_image_info *info) | |
| { | |
| struct xilinx_spi_conf *conf = mgr->priv; | |
| unsigned long timeout; | |
| int ret; | |
| if (gpiod_get_value(conf->done)) | |
| return xilinx_spi_apply_cclk_cycles(conf); | |
| timeout = jiffies + usecs_to_jiffies(info->config_complete_timeout_us); | |
| while (time_before(jiffies, timeout)) { | |
| ret = xilinx_spi_apply_cclk_cycles(conf); | |
| if (ret) | |
| return ret; | |
| if (gpiod_get_value(conf->done)) | |
| return xilinx_spi_apply_cclk_cycles(conf); | |
| } | |
| dev_err(&mgr->dev, "Timeout after config data transfer.\n"); | |
| return -ETIMEDOUT; | |
| } | |
| static const struct fpga_manager_ops xilinx_spi_ops = { | |
| .state = xilinx_spi_state, | |
| .write_init = xilinx_spi_write_init, | |
| .write = xilinx_spi_write, | |
| .write_complete = xilinx_spi_write_complete, | |
| }; | |
| static int xilinx_spi_probe(struct spi_device *spi) | |
| { | |
| struct xilinx_spi_conf *conf; | |
| conf = devm_kzalloc(&spi->dev, sizeof(*conf), GFP_KERNEL); | |
| if (!conf) | |
| return -ENOMEM; | |
| conf->spi = spi; | |
| /* PROGRAM_B is active low */ | |
| conf->prog_b = devm_gpiod_get(&spi->dev, "prog_b", GPIOD_OUT_LOW); | |
| if (IS_ERR(conf->prog_b)) { | |
| dev_err(&spi->dev, "Failed to get PROGRAM_B gpio: %ld\n", | |
| PTR_ERR(conf->prog_b)); | |
| return PTR_ERR(conf->prog_b); | |
| } | |
| conf->done = devm_gpiod_get(&spi->dev, "done", GPIOD_IN); | |
| if (IS_ERR(conf->done)) { | |
| dev_err(&spi->dev, "Failed to get DONE gpio: %ld\n", | |
| PTR_ERR(conf->done)); | |
| return PTR_ERR(conf->done); | |
| } | |
| return fpga_mgr_register(&spi->dev, "Xilinx Slave Serial FPGA Manager", | |
| &xilinx_spi_ops, conf); | |
| } | |
| static int xilinx_spi_remove(struct spi_device *spi) | |
| { | |
| fpga_mgr_unregister(&spi->dev); | |
| return 0; | |
| } | |
| static const struct of_device_id xlnx_spi_of_match[] = { | |
| { .compatible = "xlnx,fpga-slave-serial", }, | |
| {} | |
| }; | |
| MODULE_DEVICE_TABLE(of, xlnx_spi_of_match); | |
| static struct spi_driver xilinx_slave_spi_driver = { | |
| .driver = { | |
| .name = "xlnx-slave-spi", | |
| .of_match_table = of_match_ptr(xlnx_spi_of_match), | |
| }, | |
| .probe = xilinx_spi_probe, | |
| .remove = xilinx_spi_remove, | |
| }; | |
| module_spi_driver(xilinx_slave_spi_driver) | |
| MODULE_LICENSE("GPL v2"); | |
| MODULE_AUTHOR("Anatolij Gustschin <agust@denx.de>"); | |
| MODULE_DESCRIPTION("Load Xilinx FPGA firmware over SPI"); |