| TI Wilink 6/7/8 (wl12xx/wl18xx) SDIO devices | |
| This node provides properties for controlling the wilink wireless device. The | |
| node is expected to be specified as a child node to the SDIO controller that | |
| connects the device to the system. | |
| Required properties: | |
| - compatible: should be one of the following: | |
| * "ti,wl1271" | |
| * "ti,wl1273" | |
| * "ti,wl1281" | |
| * "ti,wl1283" | |
| * "ti,wl1285" | |
| * "ti,wl1801" | |
| * "ti,wl1805" | |
| * "ti,wl1807" | |
| * "ti,wl1831" | |
| * "ti,wl1835" | |
| * "ti,wl1837" | |
| - interrupts : specifies attributes for the out-of-band interrupt. | |
| Optional properties: | |
| - interrupt-parent : the phandle for the interrupt controller to which the | |
| device interrupts are connected. | |
| - ref-clock-frequency : ref clock frequency in Hz | |
| - tcxo-clock-frequency : tcxo clock frequency in Hz | |
| Note: the *-clock-frequency properties assume internal clocks. In case of external | |
| clock, new bindings (for parsing the clock nodes) have to be added. | |
| Example: | |
| &mmc3 { | |
| vmmc-supply = <&wlan_en_reg>; | |
| bus-width = <4>; | |
| cap-power-off-card; | |
| keep-power-in-suspend; | |
| #address-cells = <1>; | |
| #size-cells = <0>; | |
| wlcore: wlcore@2 { | |
| compatible = "ti,wl1835"; | |
| reg = <2>; | |
| interrupt-parent = <&gpio0>; | |
| interrupts = <19 IRQ_TYPE_LEVEL_HIGH>; | |
| }; | |
| }; |