| TPS62360 Voltage regulators | |
| Required properties: | |
| - compatible: Must be one of the following. | |
| "ti,tps62360" | |
| "ti,tps62361", | |
| "ti,tps62362", | |
| "ti,tps62363", | |
| - reg: I2C slave address | |
| Optional properties: | |
| - ti,enable-vout-discharge: Enable output discharge. This is boolean value. | |
| - ti,enable-pull-down: Enable pull down. This is boolean value. | |
| - ti,vsel0-gpio: GPIO for controlling VSEL0 line. | |
| If this property is missing, then assume that there is no GPIO | |
| for vsel0 control. | |
| - ti,vsel1-gpio: Gpio for controlling VSEL1 line. | |
| If this property is missing, then assume that there is no GPIO | |
| for vsel1 control. | |
| - ti,vsel0-state-high: Initial state of vsel0 input is high. | |
| If this property is missing, then assume the state as low (0). | |
| - ti,vsel1-state-high: Initial state of vsel1 input is high. | |
| If this property is missing, then assume the state as low (0). | |
| Any property defined as part of the core regulator binding, defined in | |
| regulator.txt, can also be used. | |
| Example: | |
| abc: tps62360 { | |
| compatible = "ti,tps62361"; | |
| reg = <0x60>; | |
| regulator-name = "tps62361-vout"; | |
| regulator-min-microvolt = <500000>; | |
| regulator-max-microvolt = <1500000>; | |
| regulator-boot-on | |
| ti,vsel0-gpio = <&gpio1 16 0>; | |
| ti,vsel1-gpio = <&gpio1 17 0>; | |
| ti,vsel0-state-high; | |
| ti,vsel1-state-high; | |
| ti,enable-pull-down; | |
| ti,enable-force-pwm; | |
| ti,enable-vout-discharge; | |
| }; |