| RT5650/RT5645 audio CODEC | |
| This device supports I2C only. | |
| Required properties: | |
| - compatible : One of "realtek,rt5645" or "realtek,rt5650". | |
| - reg : The I2C address of the device. | |
| - interrupts : The CODEC's interrupt output. | |
| Optional properties: | |
| - hp-detect-gpios: | |
| a GPIO spec for the external headphone detect pin. If jd-mode = 0, | |
| we will get the JD status by getting the value of hp-detect-gpios. | |
| - realtek,in2-differential | |
| Boolean. Indicate MIC2 input are differential, rather than single-ended. | |
| - realtek,dmic1-data-pin | |
| 0: dmic1 is not used | |
| 1: using IN2P pin as dmic1 data pin | |
| 2: using GPIO6 pin as dmic1 data pin | |
| 3: using GPIO10 pin as dmic1 data pin | |
| 4: using GPIO12 pin as dmic1 data pin | |
| - realtek,dmic2-data-pin | |
| 0: dmic2 is not used | |
| 1: using IN2N pin as dmic2 data pin | |
| 2: using GPIO5 pin as dmic2 data pin | |
| 3: using GPIO11 pin as dmic2 data pin | |
| -- realtek,jd-mode : The JD mode of rt5645/rt5650 | |
| 0 : rt5645/rt5650 JD function is not used | |
| 1 : Mode-0 (VDD=3.3V), two port jack detection | |
| 2 : Mode-1 (VDD=3.3V), one port jack detection | |
| 3 : Mode-2 (VDD=1.8V), one port jack detection | |
| Pins on the device (for linking into audio routes) for RT5645/RT5650: | |
| * DMIC L1 | |
| * DMIC R1 | |
| * DMIC L2 | |
| * DMIC R2 | |
| * IN1P | |
| * IN1N | |
| * IN2P | |
| * IN2N | |
| * Haptic Generator | |
| * HPOL | |
| * HPOR | |
| * LOUTL | |
| * LOUTR | |
| * PDM1L | |
| * PDM1R | |
| * SPOL | |
| * SPOR | |
| Example: | |
| codec: rt5650@1a { | |
| compatible = "realtek,rt5650"; | |
| reg = <0x1a>; | |
| hp-detect-gpios = <&gpio 19 0>; | |
| interrupt-parent = <&gpio>; | |
| interrupts = <7 IRQ_TYPE_EDGE_FALLING>; | |
| realtek,dmic-en = "true"; | |
| realtek,en-jd-func = "true"; | |
| realtek,jd-mode = <3>; | |
| }; |