| RT5659/RT5658 audio CODEC | |
| This device supports I2C only. | |
| Required properties: | |
| - compatible : One of "realtek,rt5659" or "realtek,rt5658". | |
| - reg : The I2C address of the device. | |
| - interrupts : The CODEC's interrupt output. | |
| Optional properties: | |
| - clocks: The phandle of the master clock to the CODEC | |
| - clock-names: Should be "mclk" | |
| - realtek,in1-differential | |
| - realtek,in3-differential | |
| - realtek,in4-differential | |
| Boolean. Indicate MIC1/3/4 input are differential, rather than single-ended. | |
| - realtek,dmic1-data-pin | |
| 0: dmic1 is not used | |
| 1: using IN2N pin as dmic1 data pin | |
| 2: using GPIO5 pin as dmic1 data pin | |
| 3: using GPIO9 pin as dmic1 data pin | |
| 4: using GPIO11 pin as dmic1 data pin | |
| - realtek,dmic2-data-pin | |
| 0: dmic2 is not used | |
| 1: using IN2P pin as dmic2 data pin | |
| 2: using GPIO6 pin as dmic2 data pin | |
| 3: using GPIO10 pin as dmic2 data pin | |
| 4: using GPIO12 pin as dmic2 data pin | |
| - realtek,jd-src | |
| 0: No JD is used | |
| 1: using JD3 as JD source | |
| - realtek,ldo1-en-gpios : The GPIO that controls the CODEC's LDO1_EN pin. | |
| - realtek,reset-gpios : The GPIO that controls the CODEC's RESET pin. | |
| Pins on the device (for linking into audio routes) for RT5659/RT5658: | |
| * DMIC L1 | |
| * DMIC R1 | |
| * DMIC L2 | |
| * DMIC R2 | |
| * IN1P | |
| * IN1N | |
| * IN2P | |
| * IN2N | |
| * IN3P | |
| * IN3N | |
| * IN4P | |
| * IN4N | |
| * HPOL | |
| * HPOR | |
| * SPOL | |
| * SPOR | |
| * LOUTL | |
| * LOUTR | |
| * MONOOUT | |
| * PDML | |
| * PDMR | |
| * SPDIF | |
| Example: | |
| rt5659 { | |
| compatible = "realtek,rt5659"; | |
| reg = <0x1b>; | |
| interrupt-parent = <&gpio>; | |
| interrupts = <TEGRA_GPIO(W, 3) GPIO_ACTIVE_HIGH>; | |
| realtek,ldo1-en-gpios = | |
| <&gpio TEGRA_GPIO(V, 3) GPIO_ACTIVE_HIGH>; | |
| }; |