| * Freescale MPC512x/MPC8xxx/QorIQ/Layerscape GPIO controller |
| |
| Required properties: |
| - compatible : Should be "fsl,<soc>-gpio" |
| The following <soc>s are known to be supported: |
| mpc5121, mpc5125, mpc8349, mpc8572, mpc8610, pq3, qoriq, |
| ls1021a, ls1043a, ls2080a. |
| - reg : Address and length of the register set for the device |
| - interrupts : Should be the port interrupt shared by all 32 pins. |
| - #gpio-cells : Should be two. The first cell is the pin number and |
| the second cell is used to specify the gpio polarity: |
| 0 = active high |
| 1 = active low |
| |
| Optional properties: |
| - little-endian : GPIO registers are used as little endian. If not |
| present registers are used as big endian by default. |
| |
| Example of gpio-controller node for a mpc5125 SoC: |
| |
| gpio0: gpio@1100 { |
| compatible = "fsl,mpc5125-gpio"; |
| #gpio-cells = <2>; |
| reg = <0x1100 0x080>; |
| interrupts = <78 0x8>; |
| }; |
| |
| Example of gpio-controller node for a ls2080a SoC: |
| |
| gpio0: gpio@2300000 { |
| compatible = "fsl,ls2080a-gpio", "fsl,qoriq-gpio"; |
| reg = <0x0 0x2300000 0x0 0x10000>; |
| interrupts = <0 36 0x4>; /* Level high type */ |
| gpio-controller; |
| little-endian; |
| #gpio-cells = <2>; |
| interrupt-controller; |
| #interrupt-cells = <2>; |
| }; |
