| # | |
| # Micrel device configuration | |
| # | |
| config NET_VENDOR_MICREL | |
| bool "Micrel devices" | |
| default y | |
| depends on (HAS_IOMEM && DMA_ENGINE) || SPI || PCI || HAS_IOMEM || \ | |
| (ARM && ARCH_KS8695) | |
| ---help--- | |
| If you have a network (Ethernet) card belonging to this class, say Y. | |
| Note that the answer to this question doesn't directly affect the | |
| kernel: saying N will just cause the configurator to skip all | |
| the questions about Micrel devices. If you say Y, you will be asked | |
| for your specific card in the following questions. | |
| if NET_VENDOR_MICREL | |
| config ARM_KS8695_ETHER | |
| tristate "KS8695 Ethernet support" | |
| depends on ARM && ARCH_KS8695 | |
| select MII | |
| ---help--- | |
| If you wish to compile a kernel for the KS8695 and want to | |
| use the internal ethernet then you should answer Y to this. | |
| config KS8842 | |
| tristate "Micrel KSZ8841/42 with generic bus interface" | |
| depends on HAS_IOMEM && DMA_ENGINE | |
| ---help--- | |
| This platform driver is for KSZ8841(1-port) / KS8842(2-port) | |
| ethernet switch chip (managed, VLAN, QoS) from Micrel or | |
| Timberdale(FPGA). | |
| config KS8851 | |
| tristate "Micrel KS8851 SPI" | |
| depends on SPI | |
| select MII | |
| select CRC32 | |
| select EEPROM_93CX6 | |
| ---help--- | |
| SPI driver for Micrel KS8851 SPI attached network chip. | |
| config KS8851_MLL | |
| tristate "Micrel KS8851 MLL" | |
| depends on HAS_IOMEM | |
| select MII | |
| ---help--- | |
| This platform driver is for Micrel KS8851 Address/data bus | |
| multiplexed network chip. | |
| config KSZ884X_PCI | |
| tristate "Micrel KSZ8841/2 PCI" | |
| depends on PCI | |
| select MII | |
| select CRC32 | |
| ---help--- | |
| This PCI driver is for Micrel KSZ8841/KSZ8842 PCI Ethernet chip. | |
| To compile this driver as a module, choose M here. The module | |
| will be called ksz884x. | |
| endif # NET_VENDOR_MICREL |