title: The ‘matrix-multiply’ binary layout: default permalink: resources/matrix-multiply shortdoc: > Source for ‘matrix-multiply’. A matrix-multiply binary runs a multiplication on two 100x100 matrixes. The sum of the multiplied matrix is printed upon completion. author: [“Bobby R. Bruce”]

The ‘matrix-multiply’ resource runs a multiplication on two 100x100 matrixes. The sum of the multiplied matrix is printed upon completion.

Building Instructions

Run make.

This will only compile the binary to the X86 ISA.

Cleaning Instructions

Run make clean in the Makefile directory.

Usage

As this binary does not contain any special m5 library code it can be run outside of a gem5 simulation:

./matrix-multiply

It can also be run in a gem5 simulation in SE mode. Below is a snippet which utilizes the gem5 standard library to do so:

board.set_se_workload(Resource("x86-matrix-multiply"))

simulator = Simulator(board = board)

Pre-built binaries

Compiled to the X86 ISA: http://dist.gem5.org/dist/develop/test-progs/matrix-multiply/x86-matrix-multiply-20220825

License

This code is covered by By the 03-Clause BSD License (BSD-3-Clause).