| adapter_khz 10000 | |
| interface ftdi | |
| ftdi_device_desc "Dual RS232-HS" | |
| ftdi_vid_pid 0x0403 0x6010 | |
| ftdi_layout_init 0x0008 0x001b | |
| ftdi_layout_signal nSRST -oe 0x0020 | |
| set _CHIPNAME riscv | |
| jtag newtap $_CHIPNAME cpu -irlen 5 -expected-id 0x20000913 | |
| set _TARGETNAME_0 $_CHIPNAME.cpu0 | |
| set _TARGETNAME_1 $_CHIPNAME.cpu1 | |
| set _TARGETNAME_2 $_CHIPNAME.cpu2 | |
| set _TARGETNAME_3 $_CHIPNAME.cpu3 | |
| set _TARGETNAME_4 $_CHIPNAME.cpu4 | |
| target create $_TARGETNAME_0 riscv -chain-position $_CHIPNAME.cpu -rtos hwthread | |
| target create $_TARGETNAME_1 riscv -chain-position $_CHIPNAME.cpu -coreid 1 | |
| target create $_TARGETNAME_2 riscv -chain-position $_CHIPNAME.cpu -coreid 2 | |
| target create $_TARGETNAME_3 riscv -chain-position $_CHIPNAME.cpu -coreid 3 | |
| target create $_TARGETNAME_4 riscv -chain-position $_CHIPNAME.cpu -coreid 4 | |
| target smp $_TARGETNAME_0 $_TARGETNAME_1 $_TARGETNAME_2 $_TARGETNAME_3 $_TARGETNAME_4 | |
| #set _TARGETNAME_0 $_CHIPNAME.cpu | |
| #target create $_TARGETNAME_0 riscv -chain-position $_TARGETNAME_0 -rtos riscv | |
| $_TARGETNAME_0 configure -work-area-phys 0x80000000 -work-area-size 10000 -work-area-backup 1 | |
| gdb_report_data_abort enable | |
| gdb_report_register_access_error enable | |
| # Expose an unimplemented CSR so we can test non-existent register access | |
| # behavior. | |
| riscv expose_csrs 2288 | |
| flash bank onboard_spi_flash fespi 0x20000000 0 0 0 $_TARGETNAME_0 0x10040000 | |
| init | |
| # Clear reset on these events, because that messes with memory which we don't | |
| # want in these tests. We want gdb be able to "download" to flash as well as | |
| # RAM, and then simply execute the program. | |
| # This must happen after init, where blank events get overwritten with reset. | |
| set targets [target names] | |
| foreach t $targets { | |
| $t configure -event gdb-flash-erase-start "" | |
| $t configure -event gdb-flash-write-end "" | |
| } | |
| reset halt | |
| # Use a modified bootloader to configure the hardware, especially the DDR controller. | |
| load_image targets/SiFive/HiFiveUnleashed_setup.bin 0x08000000 | |
| foreach t [target names] { | |
| targets $t | |
| reg pc 0x08000000 | |
| arm semihosting enable | |
| } | |
| resume | |
| wait_halt | |
| # Uncomment this if you want to be able to clobber your SPI Flash, which | |
| # probably you don't since you can do it through Linux | |
| #flash protect 0 0 last off |